Motorola SVG1501UE, SVG1501E manual Wall Mounting the SVG1501

B

8.Plug the telephone cord of a single or two-line telephone into the telephone.

9.Plug the other end of the telephone cord of a single or two-line telephone into the TEL 1/2 port on the rear of the gateway.

Note: Contact a VoIP service provider to activate this service.

10.For a second telephone, plug the telephone wire of a single-line telephone into the TEL 2 port on the rear of the SVG1501.

11.Check that the LEDs on the front panel cycle through the proper sequence, see SVG1501 LED Activity During Startup.

Wall Mounting the SVG1501

You can optionally mount the SVG1501 on a wall:

•Locate the unit as specified by the local or national codes governing residential or business cable TV and communications services.

•Follow all local standards for installing a network interface unit/network interface device (NIU/NID).

•Make sure the AC power plug is disconnected from the wall outlet and all cables are removed from the back of the SVG1501 before starting the installation.

•Decide if you want to mount the SVG1501 horizontally or vertically.

If possible, mount the unit to concrete, masonry, a wooden stud, or some other solid wall material. Use anchors if necessary (for example, if you must mount the unit on drywall).

2 • Getting Started 12