Linksys RV082 manual How many ports can be simultaneously forwarded?

Page 86

10/100 8-Port VPN Router

How many ports can be simultaneously forwarded?

Theoretically, the Router can establish 4,000 sessions at the same time, but you can only forward 30 ranges of ports.

Does the Router replace a modem? Is there a cable or DSL modem in the Router?

No, this version of the Router must work in conjunction with a cable or DSL modem.

Which modems are compatible with the Router?

The Router is compatible with virtually any cable or DSL modem that supports Ethernet.

What is the maximum number of VPN sessions allowed by the Router?

The maximum number depends on many factors. At least one IPSec session will work through the Router; however, simultaneous IPSec sessions may be possible, depending on the specifics of your VPNs.

How can I check whether I have static or DHCP IP addresses?

Ask your ISP to find out.

How do I get mIRC to work with the Router?

Under the Setup => Forwarding tab, set port forwarding to 113 for the PC on which you are using mIRC.

If your questions are not addressed here, refer to the Linksys website, www.linksys.com.

Appendix A: Troubleshooting

77

Frequently Asked Questions

Image 86
Contents 10/100 8-Port Word definition How to Use this GuideCopyright and Trademarks Table of Contents Appendix D Physical Setup of the Router Appendix a TroubleshootingAppendix B Installing the Linksys VPN Client Appendix E Battery Replacement10/100 8-Port VPN Router List of Figures VPN Router-to-VPN Router VPN21 Setup Tab Advanced Routing 51 VPN tab Client to Gateway Remote Group Setup Figure C-3 MAC Address/Physical Address IP a protocol used to send data over a network IntroductionWelcome What’s in this Guide? Adapter a device that adds network functionality to your PCIntroduction What’s in this Guide? Use of IP Addresses Networking BasicsAn Introduction to LANs Why do I need a VPN? MAC Address SpoofingWhat is a VPN? VPN Router to VPN Router VPN Router-to-VPN Router VPNGetting to Know the Router LAN WAN2 WAN1Back Panel Power Connecting the Router OverviewConnection Instructions Connect a PCSystem Summary Tab Setting Up and Configuring the RouterSetup Tab Domain a specific name for a network of computers Dhcp TabSystem Management Tab VPN Tab Port Management TabFirewall Tab Log TabSystem Information How to Access the Web-based UtilitySystem Summary Tab Port Statistics ConfigurationNetwork Setting Status Log Setting Status Firewall Setting StatusVPN Setting Status Network LAN SettingDual-WAN / DMZ Setting WAN Connection TypePptp Point-to-Point Tunneling Protocol Static IPPPPoE Point-to-Point Protocol over Ethernet most DSL users Heart Beat Signal Transparent BridgeTime Setup Tab TimeSetup Tab Password Setup Tab DMZ Host Setup Tab ForwardingPort Range Forwarding Port TriggeringSetup Tab UPnP Setup Tab One-to-One NATSetup Tab MAC Clone Setup Tab DdnsSetup Tab Advanced Routing Dynamic RoutingStatic Routing Enter the following data to create a static route entryDynamic IP Dhcp Tab SetupSetup Static IPSystem Management Tab Dual-WAN Network Service DetectionDhcp Tab Status Dual-WANBandwidth Protocol BindingSystem Management Tab Snmp 27 System Management Tab SnmpPing System Management Tab DiagnosticDNS Name Lookup Firmware Upgrade System Management Tab Factory DefaultSystem Management Tab Firmware Upgrade Firmware DownloadSystem Management Tab Restart System Management Tab Setting BackupPort Management Tab Port Setup Port Management Tab Port Status 36 Port Management Tab Port StatusRestrict WEB features Firewall Tab GeneralFirewall Tab Access Rules 38 Firewall Tab Access RulesScheduling Add a New Access RuleServices Forbidden Domains Firewall Tab Content FilterEditing an Access Rule Website Blocking by KeywordsTunnel Status VPN Tab SummarySummary GroupVPN Status VPN Clients StatusLocal Group Setup VPN Tab Gateway to GatewayRemote Group Setup 47 VPN tab Gateway to Gateway Remote Group SetupBit a binary digit IPSec SetupManual IKE with Preshared Key automatic Advanced With Tunnel Enabled VPN Tab Client to Gateway49 VPN tab Client to Gateway 51 VPN tab Client to Gateway Remote Group Setup With Group VPN enabled 52 VPN tab Client to Gateway IPSec Setup 10/100 8-Port VPN Router 53 VPN tab Client to Gateway Advanced VPN Tab VPN Client Access 54 VPN tab VPN Client AccessVPN Tab Pptp Server Users SettingVPN Tab VPN Pass Through IP Address RangeSyslog Log SettingLog Tab System Log MailLog Tab System Statistics 59 Log tab System StatisticsBasic Setup Wizard Tab62 Basic Setup Wizard Host and Domain Name Access Rule Setup 65 Access Rule Wizard What is Access Rules67 Access Rule Wizard Select the Service 69 Access Rule Wizard Select the Destination On Line Manual Support TabLogout Tab Linksys Web SiteFor Windows 98 and Millennium Appendix a TroubleshootingCommon Problems and Solutions Need to set a static IP address on a PCFor Windows For Windows XPFor Windows 98 and Millennium 10/100 8-Port VPN Router Am not able to access the Router’s Web-based Utility Setup Need to set up a server behind my RouterApplication Start and End Protocol IP Address Enable TCPApplication Start and End Protocol IP Address Enabled Can’t get the Internet game, server, or application to workFor Microsoft Internet Explorer 5.0 or higher To start over, I need to set the Router to factory defaultNeed to upgrade the firmware For Netscape 4.7 or higherFirmware upgrade failed My DSL service’s PPPoE is always disconnectingNeed to use port triggering Is IPSec Passthrough supported by the Router? Frequently Asked QuestionsWhere is the Router installed on the network? Does the Router support IPX or AppleTalk?How can I block corrupted FTP downloads? What is DMZ Hosting? Is the Router cross-platform compatible?How can I check whether I have static or Dhcp IP addresses? How many ports can be simultaneously forwarded?Which modems are compatible with the Router? How do I get mIRC to work with the Router?Appendix B Installing the Linksys VPN Client Figure B-2 Linksys VPN Installation CompleteFigure B-3 Linksys QuickVPN Windows 98 or Me Instructions Windows 2000 or XP InstructionsFor the Router’s Web-based Utility Figure C-3 MAC Address/Physical AddressPlacement of the Router Appendix D Physical Setup of the RouterSetting up the Router Rack-Mounting the Router10/100 8-Port VPN Router Wall-Mounting the Router Figure D-3 Wall-Mounting the RouterFigure D-4 Wall-Mounting Hardware Appendix E Battery Replacement Replacing a Lithium BatteryFigure F-1 Upgrade Firmware Appendix F Upgrading FirmwareNetwork Neighborhood/My Network Places Appendix G Windows HelpShared Resources Appendix H Glossary 10/100 8-Port VPN Router 10/100 8-Port VPN Router 10/100 8-Port VPN Router DMZ/Internet Port Appendix I SpecificationsStandards Ieee 802.3, 802.3u Ports SPI Firewall, DES and 3DES Encryption for IPSec VPN TunnelAppendix J Warranty Information Limited WarrantyAppendix K Regulatory Information FCC StatementInformation section in this Guide Appendix L Contact InformationNeed to contact Linksys?

RV082 specifications

The Linksys RV082 is a robust dual WAN VPN router that stands out in the market for small to medium-sized businesses seeking reliable network connectivity and security. Designed to meet the demands of a dynamic business environment, the RV082 offers a host of features that enhance both performance and reliability.

One of the primary attributes of the RV082 is its dual WAN capability. This feature allows businesses to connect to two different internet connections simultaneously, ensuring uninterrupted internet access. In case one connection fails, the router can automatically switch to the other, minimizing downtime and maintaining productivity. This failover capability is essential for businesses that rely heavily on internet connectivity.

The RV082 also boasts impressive VPN support, enabling secure communication between remote users and branch offices. With support for up to 50 simultaneous VPN connections, the router accommodates a growing workforce that may require access to the company’s network from remote locations. This is particularly beneficial for businesses with telecommuting employees or those that operate across multiple locations.

Security is a paramount concern for any business, and the RV082 addresses this with various built-in security features. It utilizes advanced firewall capabilities, including Stateful Packet Inspection (SPI) and Denial of Service (DoS) protection, safeguarding internal networks from external threats. The router also supports strong encryption protocols such as IPSec and PPTP, ensuring that sensitive data transmitted over the VPN remains secure.

Performance-wise, the RV082 includes eight switched LAN ports, allowing numerous devices to connect directly to the network without the need for additional hardware. This feature simplifies network management and helps keep connectivity organized. Furthermore, the router supports Quality of Service (QoS) prioritization, which allows businesses to allocate bandwidth effectively among different applications and users, promoting seamless performance even during high traffic periods.

The user-friendly web-based interface facilitates easy configuration and management, making it accessible for users with varying levels of technical expertise. Additionally, the RV082’s compact design ensures that it can fit into nearly any office environment without taking up too much space.

In summary, the Linksys RV082 is an excellent choice for businesses looking for a dependable and secure networking solution. With its dual WAN capabilities, extensive VPN support, robust security features, and user-friendly management tools, the RV082 successfully meets the challenging needs of modern business networking.