Analog Devices 82-0000603-01 Expansion Interface P1, P2, P3, FlashLINK P4, Audio P5, P6

Page 44

4.5.1Expansion Interface (P1, P2, P3)

Three board-to-board connector footprints provide the signals for most of the DSP peripheral interfaces. Analog Devices does not populate these connectors or provide any additional support for this interface. See section 4.2.3, for more information on the Expansion Interface. Contact Samtec for the availability and pricing of these connectors.

Part Description		Manufacturer	Part Number
90	Position 0.05” Spacing (P1,	Samtec	SFM-145-01-S-D
P2, P3)
	Mating Connector
90	Position 0.05” Spacing	Samtec	TFM-145-x1 Series
(Through Hole)
90	Position 0.05” Spacing	Samtec	TFM-145-x2 Series
(Surface Mount)
90	Position 0.05” Spacing (Low	Samtec	TFC-145 Series
Cost)

4.5.2FlashLINK (P4)

The FlashLINK connector allows you to configure and program the STMicroelectronics DSM2150 flash/PLD chip. See section 3.5, for more information about using the FlashLINK connector.

Part Description	Manufacturer	Part Number
Right-angle 7X2 Shrouded 0.1	TYCO	2-767004-2
spacing
	Mating Assembly
FlashLINKTM JTAG	ST Micro	FL-101B
Programmer

4.5.3Audio (P5, P6)

There are two 3.5mm stereo audio jacks: one input, and one output.

Part Description	Manufacturer	Part Number
3.5mm stereo jack (P5, P6)	Shogyo	SJ-0359AM-5
	Mating Cable
3.5mm stereo plug to 3.5mm	Radio Shack	42-2387A
stereo cable

ADSP-21535 EZ-KIT Lite Evaluation System Manual	4-12

Image 44

Contents ADSP-21535 EZ-KIT LITE Limited Warranty Regulatory Compliance Table of Contents Index List of Tables List of FiguresIntroduction Analog Devices ADSP-21535 DSPSdram For More Information About Analog Devices ProductsIntended Audience For Technical or Customer SupportPurpose of This Manual Manual Contents Online HelpDocument Name Description ADSP-21535 Sharc DSPOverview Contents of your EZ-KIT Lite PackageGetting Started PC Configuration Installation TasksInstalling the EZ-KIT Lite Debug Software Installing the VisualDSP++ SoftwareInstalling the VisualDSP++ License Setting Up the EZ-KIT Lite Hardware EZ-KIT Lite Hardware SetupInstalling the EZ-KIT Lite USB Driver Windows 98 USB Driver InstallationSearch for the driver Driver is located Open the .sys File Finish the Software Installation Windows 2000 USB Driver Installation 10 Found New Hardware Wizard11 Search for a Suitable Driver 12 Locate Driver Files 13 Driver File Search Results 14 Completing Driver Installation Dialog Box Verifying Driver InstallationStarting VisualDSP++ Click on New SessionUsing the EZ-KIT Lite Using the Programmable Flag Pins SectionMemory Map Start Address End Address ContentEZ-KIT Lite License Restrictions Register Value Function Using the Sdram InterfaceUsing Flash Memory 0x200A 0x2002 0x2000 0x2001 00FFUsing the Programmable Flag Pins Flag Connected UseUsing the Power Management Features Using the Flash Programmer UtilityPF14 PF13 PF12 Example ProgramsEZ-KIT Lite Hardware Reference System Architecture SectionDSP System ArchitectureExternal Bus Interface SPORT0 Audio InterfaceJtag Emulation Port Connector InterfacesExpansion Interface Jumper and DIP Switch Settings Audio Input Select Jumper JP1Stereo Linein Default Audio Codec Disable Jumper JP2Boot Mode Select Switch SW1 DSP PLL Setup Switch SW2DSP Pin Switch Position Default PLL Setup Switch Settings SW2LEDs and Push Buttons LED and Push Button LocationsPower LED LED6 Reset LEDs LED7, LED8Programmable Flag LEDs LED1, LED2, LED3, LED4 USB Monitor LED LED5Push Button DSP Programmable Reset Push Button SW8Programmable Flag Push Buttons SW4, SW5, SW6, SW7 Connectors Connector LocationsExpansion Interface P1, P2, P3 Part Description Manufacturer Part NumberFlashLINK P4 Audio P5, P6USB P7 Jtag P8SPORT0 P9 Power Connector P10Specifications Power Supply Terminal ConnectionBoard Current Measurements Resistor Voltage Plane DescriptionMechanical Dimensions Mechanical DrawingAppendix a Bill of Materials Description Ref. Des Manufacturer Part Number3V-1.0AMP Regulator CT1 DIG01 PCT3226CT-ND Tant Panasonic ECJ-2VC1H390J NPO Appendix B Schematic ADSP-21535 EZ-KIT Lite For RTC ADSP-21535 EZ-KIT Lite DSP Memory ADSP-21535 EZ-KIT Lite Audio Codec ADSP-21535 EZ-KIT Lite Config Analog ADSP-21535 EZ-KIT Lite Connectors ADSP-21535 EZ-KIT Lite Power ADSP-21535 EZ-KIT Lite Power ADSP-21535 EZ-KIT Lite Bypass Caps Index 4-5SPORT0