TV sensor connections, PCS connections

Connection and Wiring

For additional information concerning the IR emitter, refer to the IR Sensors and

Receivers instruction manual.

4.Attach the IR shield, with IR emitter diode, to the television IR window, ensuring that the IR emitter diode is properly positioned in the television input IR window.

5.Press firmly to activate the pressure-sensitive adhesive of the IR shield.

TV sensor connections

FIG. 8 shows how to connect the CC-XPS to the TV sensor connector to detect horizontal scan frequencies up to 65 kHz.

CC-IRC

TV sensor	GND
connector	SENSOR
	SENSOR

FIG. 8 TV sensor wiring connections

Television

PCS connections

The optional AMX Power Current Sensor (PCS) provides power sensing for equipment that does not generate horizontal scan frequencies. Connect the optional PCS as shown in FIG. 9 for automated power control using Send_Commands PON and POF. A PIN command must be sent to the AXB-TM5 either from terminal mode or from within an Axcess program. If PIN is not used, then the PCS state is received as [TM-Device, 251] for I/O 1.

Input/ Output

GND

I/O 1

I/O 2

I/O 3

I/O 4 12 VDC PWR

GND

STANDBY

PWR

PCS

FIG. 9 PCS connections

AXlink data and 12 VDC power supply connections

Connect the control system's AXlink connector to the AXlink connector and an external 12 VDC power supply on the rear panel of the AXB-TM5 as shown in FIG. 10.

	6	AXB-TM5 Television Manager