AMX Programming, Channel Setting Commands, AXB-TM5 Channel Settings, Device Assignment

Page 13

Programming

Programming

You can program the AXB-TM5 to perform a wide variety of operations using Axcess Send_Commands. This section describes channel settings, IR functions, and system Send_Commands. Refer to the AXCESS Programming Guide for additional programming information.

Channel Setting Commands

The AXB-TM5 use the channel setting commands listed in the following table.

AXB-TM5 Channel Settings

Channel	Function

1	Generates IR/Serial functions 1, else Off

2 - 127	Channels the generate IR code for the corresponding functions

128 - 247	Push and release channels for received IR code

248	A push on this channel indicates a power failure error

249	Response LED blinks when channels 249 and 250 are On

250	Response LED lights when channel is On

251	I/O is On (switch to GND) when channel is On

252	I/O 2 is On (switch to GND) when channel is On

253	I/O 3 is On (switch to GND) when channel is On

254	I/O 4 is On (switch to GND) when channel is On

255	Channel is On if the TV Power Sensor detects a horizontal scan frequency

Turning a channel (IR/Serial function) on while another one is currently on will automatically turn the current one off first. Contact closure inputs on I/O 1 through I/O 4 will also generate PUSHes and RELEASEs on channels 251 through 254, respectively.

Device Assignment

The device assignment must be the same as the device number set on the Device DIP switches

(FIG. 2 on page 3).

AXB-TM5 Television Manager	9

Image 13

Contents AXB-TM5 AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Specifications SpecificationsProduct Information Front PanelRear Panel Components Front Panel ComponentsDevice DIP Switch Connection and WiringDevice DIP switch settings Position ValuePreparing/connecting captive wires Wiring the Rear PanelWiring Guidelines Wiring Guidelines @ 200 mAIR emitter to device installation CC-IRC emitter wiring connectionsTV sensor connections AXlink data and 12 VDC power supply connectionsPCS connections IRX-SM connections AXlink 12 VDC power supply wiring exampleConnection and Wiring AXB-TM5 Channel Settings Channel Setting CommandsProgramming Device AssignmentSystem SendCommands System SendCommandsSendcommand AXBTMX,?CTON Sendcommand AXBTMX,CTON,20Sendcommand AXBTMX,DC,145,24 Sendcommand AXBTMX,DE,10Sendcommand AXBTMX,DK Sendcommand AXBTMX,?DESendcommand AXBTMX,PIF Sendcommand AXBTMX,PINSendcommand AXBTMX,?PTOF Sendcommand AXBTMX,PTOF,15Sendcommand AXBTMX,PTON,20 Sendcommand AXBTMX,?PTONSendcommand AXBTMX,SP,25 Sendcommand AXBTMX,RO,5Sendcommand DEV,XCH Channel RO,offsetSendcommand AXBTMX,XCH Sendcommand DEV,XCH-ModeSendcommand IR1, XCH XchmAMX reserves