AMX AXB-TM5 instruction manual IRX-SM connections, AXlink 12 VDC power supply wiring example

Page 11

PWR

GND

PWR

AXP

AXM

GND

FIG. 10 AXlink 12 VDC power supply wiring example

Connection and Wiring

12 VDC power supply

PWR

AXP

AXM

GND

If you are using power from AXlink, disconnect the wiring from the Axcess Control System before wiring the AXB-TM5.

Use a 12 VDC power supply when the distance between the control system and AXB-TM5 exceeds the limits described in the Wiring Guidelines section on page 4. Make sure to connect only the GND wire on the AXlink connector when using a 12 VDC power supply. Do not connect the PWR wire to the AXlink connector's PWR (+) terminal.

IRX-SM connections

Connect one or more (eight maximum in parallel) optional IRX-SM sensors to the AXB-TM5 as shown in FIG. 11. You can also use TX-series wired control panels.

GND

OUT

IRX-SM #2

AUX OUT

+12 VDC

GND		GND
IN		OUT
To IRX-SG		IRX-SM #1
AUX		AUX OUT
PWR		+12 VDC
FIG. 11 IRX-SM connections
FIG. 11 IRX-SM connections

This configuration is for 40 kHz operation only.

AXB-TM5 Television Manager	7

Image 11

Contents AXB-TM5 AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Front Panel SpecificationsSpecifications Product InformationRear Panel Components Front Panel ComponentsPosition Value Connection and WiringDevice DIP Switch Device DIP switch settingsWiring Guidelines @ 200 mA Wiring the Rear PanelPreparing/connecting captive wires Wiring GuidelinesIR emitter to device installation CC-IRC emitter wiring connectionsPCS connections AXlink data and 12 VDC power supply connectionsTV sensor connections IRX-SM connections AXlink 12 VDC power supply wiring exampleConnection and Wiring Device Assignment Channel Setting CommandsAXB-TM5 Channel Settings ProgrammingSystem SendCommands System SendCommandsSendcommand AXBTMX,DE,10 Sendcommand AXBTMX,CTON,20Sendcommand AXBTMX,?CTON Sendcommand AXBTMX,DC,145,24Sendcommand AXBTMX,PIN Sendcommand AXBTMX,?DESendcommand AXBTMX,DK Sendcommand AXBTMX,PIFSendcommand AXBTMX,?PTON Sendcommand AXBTMX,PTOF,15Sendcommand AXBTMX,?PTOF Sendcommand AXBTMX,PTON,20RO,offset Sendcommand AXBTMX,RO,5Sendcommand AXBTMX,SP,25 Sendcommand DEV,XCH ChannelXchm Sendcommand DEV,XCH-ModeSendcommand AXBTMX,XCH Sendcommand IR1, XCHAMX reserves

FIG. 10 AXlink 12 VDC power supply wiring example

IRX-SM connections

FIG. 11 IRX-SM connections