Antec DF-35 user manual External 3.5 Device Installation

Page 17

Make sure to install screws on the left side…

…as well as the right side.

4.Mount any other 3.5” HDD devices accordingly.

5.Connect the appropriate power and data cables to the device(s), using cable routing as desired.

6.Close the Fleet-Release™ access door.

2.6

EXTERNAL 3.5” DEVICE INSTALLATION

There is one external 3.5” drive bay under the 5.25” drive bays.

Remove this drive bay cover.

1.Carefully remove the 3.5” drive bay cover from the bezel. Load the drives from the front, lining them up to the front of the drive cage.

17

Image 17
Contents Advanced Gaming Force DF-35 USER’S Manual Table of Contents Introduction Getting to Know Your Case Case Specifications Before YOU Begin Locating and Positioning Your Computer Installation Setting UP Page Motherboard Installation Now remove your motherboard by lifting it up Standard ATX Power Supply Installation Cable Management Internal 3.5 Device Installation External 3.5 Device Installation Preparing Your FLEET-SWAP Sata Bays for USE Using FLEET-SWAPMoving or removing a Fleet-Swap bay One example of Ahci configuration your motherboard may vary Grasp the top and bottom of your HDD. Now pull the HDD free Using the TOP 2.5 HOT-SWAP BAY External 5.25 Device Installation Internal 2 Device Installation Front I/O AC’97 / HD Audio Ports Rewiring Motherboard Header Connections Power Switch / Reset Switch / Hard Disk Drive LED ConnectorsSystem Included Fans Front 120 MM White LED Fans TOP 140 MM Twocool FANOptional Fans Rear Exhaust 120 MM Twocool White LED FansWashable AIR Filters Version 1.0.0 06/28/2010