Antec DF-35 user manual Using the TOP 2.5 HOT-SWAP BAY

Page 22

2.8

USING THE TOP 2.5” HOT-SWAP BAY

The DF-35’s top 2.5” hard drive bay is hot-swap capable. To use the hot-swap feature, ensure that your motherboard is configured for hot-swap. Make sure to install all related drivers that come with your motherboard and turn on the AHCI function in the BIOS to activate the hot swap feature.

Using the top 2.5” hot-swap drive bay

A.LOADING:

1.Align your SATA HDD with the drive bay with the connector facing the case.

2.Push the HDD all the way into the bay until it locks into position.

B.UNLOADING:

1.Ensure that your HDD is not in use.

2.Carefully pull the HDD out of the hot-swap drive bay.

22

Image 22
Contents Advanced Gaming Force DF-35 USER’S Manual Table of Contents Introduction Getting to Know Your Case Case Specifications Before YOU Begin Locating and Positioning Your Computer Installation Setting UP Page Motherboard Installation Now remove your motherboard by lifting it up Standard ATX Power Supply Installation Cable Management Internal 3.5 Device Installation External 3.5 Device Installation Using FLEET-SWAP Preparing Your FLEET-SWAP Sata Bays for USEMoving or removing a Fleet-Swap bay One example of Ahci configuration your motherboard may vary Grasp the top and bottom of your HDD. Now pull the HDD free Using the TOP 2.5 HOT-SWAP BAY External 5.25 Device Installation Internal 2 Device Installation Front I/O AC’97 / HD Audio Ports Power Switch / Reset Switch / Hard Disk Drive LED Connectors Rewiring Motherboard Header ConnectionsSystem Included Fans TOP 140 MM Twocool FAN Front 120 MM White LED FansRear Exhaust 120 MM Twocool White LED Fans Optional FansWashable AIR Filters Version 1.0.0 06/28/2010