Insert your drive as shown.
2.With one hand supporting the drive, fasten the drive with the screws provided.
3.Find a small 4-pin white connector on the power supply and connect it to the male 4-pin connector on the floppy drive.
The DF-35 includes one set of Fleet-SwapTM3.5” drive bays. Each set contain two connectors, for a total of two hot-swappable SATA drive bays, pre-installed on the bottom of the internal 3.5” drive cage.
A.PREPARING YOUR FLEET-SWAP™ SATA BAYS FOR USE
1.Remove the left side panel of the case. Open the Fleet-ReleaseTMAccess Door by pressing the left side to release it, then swing it open. Locate the Fleet-Swap bays inside the drive cage.
Fleet-Swap™ default locations
18
