D-Link DGS-1216T manual Rack Mounting, Attach the adhesive rubber pads to the bottom

Page 16

Leave at least 10cm of space at the front and rear of the hub for ventilation.

Install the Switch on a sturdy, level surface that can support its weight, or in an EIA standard-size equipment rack. For information on rack installation, see the next section, Rack Mounting.

When installing the Switch on a level surface, attach the rubber feet to the bottom of each device. The rubber feet cushion the hub and protect the hub case from scratching.

Figure 1. Attach the adhesive rubber pads to the bottom

Rack Mounting

The switch can be mounted in an EIA standard-size, 19-inch rack, which can be placed in a wiring closet with other equipment. Attach the mounting brackets at the switch’s front panel (one on each side), and secure them with the provided screws.

Figure 2. Combine the Switch with the provided screws

10

Image 16

Contents LinkDGS-1216T Building Networks for PeoplePage Table of Content Page Technical Specifications Iii Page Purpose Terms/UsagePage Gigabit Ethernet Technology IntroductionFast Ethernet Technology Switching Technology Features Vlan Virtual Local Area NetworkPage Page Installation UnpackingRack Mounting Attach the adhesive rubber pads to the bottomConnecting Network Cable AC PowerPage LED Indicator Front PanelGigabit Ethernet Ports Port 1~16 Mini Gbic PortsReset AC Power ConnectorRear Panel Power and System LEDs Understanding LED IndicatorsPorts 1~16 Status LEDs Link/ACT Link/ActivityNetwork, the Link/ACT LED lights on Installing the Web Management Utility ConfigurationDiscovery List Web Management UtilitySystem word definitions in the Discovery List Monitor ListSystem word definitions in the Monitor List Trap information Device Setting Configuration SettingFirmware upgrade ToolbarConfiguring the Switch Login Setup Menu Device StatusSetup menu Configuring Setup Setting Port SettingsDefault Priority Speed/DisableFlow Control Page Vlan Settings Virtual Local Area Network Port VID SettingTrunk Setting Mirror SettingIeee 802.1P QoS Setting Spanning Tree SettingSpanning Tree Setting Snmp Setting Traps MIBsConfigure Snmp Community Snmp Community SettingDelete Snmp Community group Configure Snmp Trap Configure Snmp Trap SettingDelete Snmp Trap Jumbo Frame Setting Device StatusStatistic Device statisticSystem Setting System settingTrap Setting Trap SettingAbnormal* 50 error packet count within 10 seconds Set PasswordBackup Setting Reset SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA