D-Link DGS-1216T manual Speed/Disable, Flow Control, Default Priority

Page 35

2.The priority of Gigabit Fiber port is higher than Copper.

To change the port setting, click on the ID parameter to enter to the selected port to configure its Speed/Disable and Flow control setting.

Figure 18.

Speed/Disable:

This setting has six modes—100M Full, 100M Half, 10M Full, 10M Half, Auto and Disable—for speed or port disable selections.

Flow Control:

This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable for avoiding data transfer overflow. Or it sets to Disable; there is either no flow control or other hardware/software management.

When the port is set to forced mode, then the flow control will automatically set to Disable.

Default Priority:

29

Image 35

Contents Building Networks for People LinkDGS-1216TPage Table of Content Page Technical Specifications Iii Page Terms/Usage PurposePage Introduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching Technology Vlan Virtual Local Area Network FeaturesPage Page Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network CablePage Mini Gbic Ports LED IndicatorFront Panel Gigabit Ethernet Ports Port 1~16Rear Panel AC Power ConnectorReset Understanding LED Indicators Power and System LEDsLink/ACT Link/Activity Ports 1~16 Status LEDsNetwork, the Link/ACT LED lights on Configuration Installing the Web Management UtilityWeb Management Utility Discovery ListSystem word definitions in the Monitor List Monitor ListSystem word definitions in the Discovery List Trap information Configuration Setting Device SettingToolbar Firmware upgradeConfiguring the Switch Login Device Status Setup MenuSetup menu Port Settings Configuring Setup SettingFlow Control Speed/DisableDefault Priority Page Port VID Setting Vlan Settings Virtual Local Area NetworkMirror Setting Trunk SettingSpanning Tree Setting Ieee 802.1P QoS SettingSpanning Tree Setting Snmp Setting MIBs TrapsSnmp Community Setting Configure Snmp CommunityDelete Snmp Community group Configure Snmp Trap Setting Configure Snmp TrapDelete Snmp Trap Device Status Jumbo Frame SettingDevice statistic StatisticSystem setting System SettingTrap Setting Trap SettingSet Password Abnormal* 50 error packet count within 10 secondsReset Setting Backup SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA