D-Link DGS-1216T Front Panel, LED Indicator, Gigabit Ethernet Ports Port 1~16, Mini Gbic Ports

Page 19

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators of the Switch.

Front Panel

The figure below shows the front panels of the Switch.

Figure 4. Front panel of 16-port Gigabit Ethernet Switch

LED Indicator:

Comprehensive LED indicators display the status of the switch and the network (see the LED Indicators chapter below).

Gigabit Ethernet Ports (Port 1~16):

The Switch sixteen Gigabit twisted pair ports, supported auto negotiable 10/100/1000Mbps and auto MDI/MDIX crossover detection function, this

function gives true “plug and play” capability, just need to plug-in the network cable to the hub directly and don’t care if the end node is NIC (Network Interface Card) or switch and hub. These ports can operate in half-duplex mode for 10/100Mbps and full- duplex mode for 10/100/1000Mbps.

Mini GBIC Ports

The Switch is equipped with two mini-GBIC ports, supported optional 1000BASE-SX/LX mini-GBIC module.

Note: When the port was set to “Forced Mode”, the Auto MDI/MDIX will be disabled.

13

Image 19

Contents Building Networks for People LinkDGS-1216TPage Table of Content Page Technical Specifications Iii Page Terms/Usage PurposePage Introduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching Technology Vlan Virtual Local Area Network FeaturesPage Page Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network CablePage Mini Gbic Ports LED IndicatorFront Panel Gigabit Ethernet Ports Port 1~16Reset AC Power ConnectorRear Panel Understanding LED Indicators Power and System LEDsLink/ACT Link/Activity Ports 1~16 Status LEDsNetwork, the Link/ACT LED lights on Configuration Installing the Web Management UtilityWeb Management Utility Discovery ListSystem word definitions in the Discovery List Monitor ListSystem word definitions in the Monitor List Trap information Configuration Setting Device SettingToolbar Firmware upgradeConfiguring the Switch Login Device Status Setup MenuSetup menu Port Settings Configuring Setup SettingDefault Priority Speed/DisableFlow Control Page Port VID Setting Vlan Settings Virtual Local Area NetworkMirror Setting Trunk SettingSpanning Tree Setting Ieee 802.1P QoS SettingSpanning Tree Setting Snmp Setting MIBs TrapsSnmp Community Setting Configure Snmp CommunityDelete Snmp Community group Configure Snmp Trap Setting Configure Snmp TrapDelete Snmp Trap Device Status Jumbo Frame SettingDevice statistic StatisticSystem setting System SettingTrap Setting Trap SettingSet Password Abnormal* 50 error packet count within 10 secondsReset Setting Backup SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA