D-Link DGS-1216T manual Ieee 802.1P QoS Setting, Spanning Tree Setting

Page 39

The selection of the sniffer mode is as follow:

TX (transmit) mode: this mode will duplicate the data transmit from the source port and forward to the sniffer port.

RX (receive) mode: this mode will duplicate the data that send to the source and forward to the sniffer port.

Both (transmit and receive) mode: this mode will duplicate both the data transmit from and data that send to the source port, then it will forward to the sniffer port.

Figure 22. Mirror setting

IEEE 802.1P QoS Setting

To set the Switch QoS base on IEEE 802.1p,

Figure 23. IEEE 802.1P-based QoS setting

Spanning Tree Setting

This Switch supports the 802.1d Spanning Tree Protocol.

Every segment will have a single path to the root bridge. All bridges listen for BPDU packets. However, BPDU packets are sent

33

Image 39

Contents Building Networks for People LinkDGS-1216TPage Table of Content Page Technical Specifications Iii Page Terms/Usage PurposePage Introduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching Technology Vlan Virtual Local Area Network FeaturesPage Page Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network CablePage Mini Gbic Ports LED IndicatorFront Panel Gigabit Ethernet Ports Port 1~16AC Power Connector ResetRear Panel Understanding LED Indicators Power and System LEDsLink/ACT Link/Activity Ports 1~16 Status LEDsNetwork, the Link/ACT LED lights on Configuration Installing the Web Management UtilityWeb Management Utility Discovery ListMonitor List System word definitions in the Discovery ListSystem word definitions in the Monitor List Trap information Configuration Setting Device SettingToolbar Firmware upgradeConfiguring the Switch Login Device Status Setup MenuSetup menu Port Settings Configuring Setup SettingSpeed/Disable Default PriorityFlow Control Page Port VID Setting Vlan Settings Virtual Local Area NetworkMirror Setting Trunk SettingSpanning Tree Setting Ieee 802.1P QoS SettingSpanning Tree Setting Snmp Setting MIBs TrapsSnmp Community Setting Configure Snmp CommunityDelete Snmp Community group Configure Snmp Trap Setting Configure Snmp TrapDelete Snmp Trap Device Status Jumbo Frame SettingDevice statistic StatisticSystem setting System SettingTrap Setting Trap SettingSet Password Abnormal* 50 error packet count within 10 secondsReset Setting Backup SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA