D-Link DGS-1216T manual Login

Page 31

Login

Before you configure this device, note that when the Web Smart Switch is configured through an Ethernet connection, make sure the manager PC must be set on same the IP network. For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter IP address http://192.168.0.1 (the factory-default IP address setting) to the address location.

Figure 13.

Or through the Web Management Utility, you do not need to remember the IP Address, select the device shown in the Monitor List of the Web Management Utility to settle the device on the Web Browser.

When the following dialog page appears, remain enter the default password "admin" and press Login to enter the main configuration window.

Figure 14.

25

Image 31

Contents Building Networks for People LinkDGS-1216TPage Table of Content Page Technical Specifications Iii Page Terms/Usage PurposePage Introduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching Technology Vlan Virtual Local Area Network FeaturesPage Page Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network CablePage Mini Gbic Ports LED IndicatorFront Panel Gigabit Ethernet Ports Port 1~16Reset AC Power ConnectorRear Panel Understanding LED Indicators Power and System LEDsLink/ACT Link/Activity Ports 1~16 Status LEDsNetwork, the Link/ACT LED lights on Configuration Installing the Web Management UtilityWeb Management Utility Discovery ListSystem word definitions in the Discovery List Monitor ListSystem word definitions in the Monitor List Trap information Configuration Setting Device SettingToolbar Firmware upgradeConfiguring the Switch Login Device Status Setup MenuSetup menu Port Settings Configuring Setup SettingDefault Priority Speed/DisableFlow Control Page Port VID Setting Vlan Settings Virtual Local Area NetworkMirror Setting Trunk SettingSpanning Tree Setting Ieee 802.1P QoS SettingSpanning Tree Setting Snmp Setting MIBs TrapsSnmp Community Setting Configure Snmp CommunityDelete Snmp Community group Configure Snmp Trap Setting Configure Snmp TrapDelete Snmp Trap Device Status Jumbo Frame SettingDevice statistic StatisticSystem setting System SettingTrap Setting Trap SettingSet Password Abnormal* 50 error packet count within 10 secondsReset Setting Backup SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA