D-Link DGS-1216T manual Rear Panel, AC Power Connector, Reset

Page 20

Rear Panel

●

Reset button

Figure 5. Rear panel of the Switch

AC Power Connector:

This is a three-pronged connector that supports the power cord. Plug in the female connector of the provided power cord into this connector, and the male into a power outlet. Supported input voltages range from 100-240V AC at 50-60Hz.

Reset:

The Reset button is to reset all the setting back to the factory default.

Note: Be sure that you recorded the setting of your device, else all the setting will be erased when pressing the “Reset” button.

14

Image 20

Contents LinkDGS-1216T Building Networks for PeoplePage Table of Content Page Technical Specifications Iii Page Purpose Terms/UsagePage Gigabit Ethernet Technology IntroductionFast Ethernet Technology Switching Technology Features Vlan Virtual Local Area NetworkPage Page Installation UnpackingRack Mounting Attach the adhesive rubber pads to the bottomConnecting Network Cable AC PowerPage LED Indicator Front PanelGigabit Ethernet Ports Port 1~16 Mini Gbic PortsRear Panel AC Power ConnectorReset Power and System LEDs Understanding LED IndicatorsPorts 1~16 Status LEDs Link/ACT Link/ActivityNetwork, the Link/ACT LED lights on Installing the Web Management Utility ConfigurationDiscovery List Web Management UtilitySystem word definitions in the Monitor List Monitor ListSystem word definitions in the Discovery List Trap information Device Setting Configuration SettingFirmware upgrade ToolbarConfiguring the Switch Login Setup Menu Device StatusSetup menu Configuring Setup Setting Port SettingsFlow Control Speed/DisableDefault Priority Page Vlan Settings Virtual Local Area Network Port VID SettingTrunk Setting Mirror SettingIeee 802.1P QoS Setting Spanning Tree SettingSpanning Tree Setting Snmp Setting Traps MIBsConfigure Snmp Community Snmp Community SettingDelete Snmp Community group Configure Snmp Trap Configure Snmp Trap SettingDelete Snmp Trap Jumbo Frame Setting Device StatusStatistic Device statisticSystem Setting System settingTrap Setting Trap SettingAbnormal* 50 error packet count within 10 seconds Set PasswordBackup Setting Reset SettingLogout LogoutTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA