D-Link DGS-1005G manual Features

Page 10

ENGLISH

Features

The DGS-1005G 5-port 10/100/1000BASE-T Gigabit Ethernet Switch was designed for easy installation and high performance in an environment where traffic on the network and the number of users increase continuously.

•Five (5) 10/100/1000BASE-T Gigabit Ethernet ports

•Supports Auto-Negotiation for 10/100/1000Mbps and duplex mode

•Supports Auto-MDI/MDI-X for each port

•Supports Full/Half duplex transfer mode for 10 and 100Mbps

•Supports Full-duplex transfer mode for 1000Mbps

•Supports IEEE 802.1p Priority Queuing, up to 4 queues

•Full wire speed reception and transmission

•Store-and-Forward switching method

•Supports 4K absolute MAC addresses

•Extensive front-panel diagnostic LEDs

•Jumbo Frame 9000 Bytes in 1000Mbs Mode

•IEEE 802.3x flow control for full duplex

•Back pressure flow control for half duplex

10

Image 10

Contents Page Preface Revision DateTable of Contents Safety Instructions Safety CautionsEnglish Protecting Against Electrostatic Discharge Setup IntroductionFast Ethernet Technology Gigabit Ethernet Technology802.1p Priority Tagging Switching TechnologyJumbo Frame Support Features Hardware Overview Top Panel LEDsLink/Act/Speed Power IndicatorCable Diagnostics − LED Indications Open, Short, or Improper TerminationRear Panel Connections Power JackAuto MDI/MDI-X Ports Installation Before You Connect to the NetworkMounting on a cement wall Mounting the Switch on the WallMounting on a wood wall Connecting To Network Backbone or Server Connecting the SwitchHub/Switch to DGS-1005G DGS-1005G to End NodeTroubleshooting Does the DGS-1005G switch have an uplink port?Networking Basics Check your IP addressStatically Assign an IP address StepGlossary Bootp CSMA/CDLAN IPXMDI Rmon MDI-XMIB RPSUDP TCP/IPTftp VlanTechnical Specifications EMIPacket Filtering / Forwarding Rate RJ-45 Pin SpecificationsMAC Address Learning Phone Support Contacting Technical SupportInternet Support Registration