D-Link DGS-1005G manual Networking Basics, Check your IP address

Page 18

Networking Basics

Check your IP address

After you install your new D-Link adapter or if you already have an Ethernet adapter installed on your computer, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. router) automatically. To verify your IP address, please follow the steps below.

•Click on Start > Run. In the run box type cmd and click OK. (Windows® 7 and Vista® users type cmd in the Start Search box.)

•At the prompt, type ipconfig and press Enter.

•This will display the IP address, subnet mask, and the default gateway of your adapter.

ENGLISH

18

Image 18

Contents Page Preface Revision DateTable of Contents Safety Instructions Safety CautionsEnglish Protecting Against Electrostatic Discharge Setup IntroductionFast Ethernet Technology Gigabit Ethernet TechnologySwitching Technology 802.1p Priority TaggingJumbo Frame Support Features Hardware Overview Top Panel LEDsLink/Act/Speed Power IndicatorCable Diagnostics − LED Indications Open, Short, or Improper TerminationPower Jack Rear Panel ConnectionsAuto MDI/MDI-X Ports Installation Before You Connect to the NetworkMounting the Switch on the Wall Mounting on a cement wallMounting on a wood wall Connecting To Network Backbone or Server Connecting the SwitchHub/Switch to DGS-1005G DGS-1005G to End NodeTroubleshooting Does the DGS-1005G switch have an uplink port?Networking Basics Check your IP addressStatically Assign an IP address StepGlossary Bootp CSMA/CDIPX LANMDI Rmon MDI-XMIB RPSUDP TCP/IPTftp VlanTechnical Specifications EMIRJ-45 Pin Specifications Packet Filtering / Forwarding RateMAC Address Learning Contacting Technical Support Phone SupportInternet Support Registration