D-Link DGS-1005G manual Ipx, Lan, Mdi

Page 22

ENGLISH

Fast Ethernet

100Mbps technology based on the Ethernet/CD network access method.

Flow Control – (IEEE 802.3x)

A means of holding packets back at the transmit port of the connected end station. Prevents packet loss at a congested switch port.

Forwarding

The process of sending a packet toward its destination by an internetworking device.

Full Duplex

A system that allows packets to be transmitted and received at the same time and, in effect, doubles the potential throughput of a link.

Half Duplex

A system that allows packets to be transmitted and received, but not at the same time. Contrast with full duplex.

IP Address

Internet Protocol address. A unique identifier for a device attached to a network using TCP/IP. The address is written as four octets separated with full-stops (periods), and is made up of a network section, an optional subnet section and a host section.

IPX

Internetwork Packet Exchange. A protocol allowing communication in a NetWare network.

LAN

Local Area Network. A network of connected computing resources (such as PCs, printers, servers) covering a relatively small geographic area (usually not larger than a floor or building). Characterized by high data rates and low error rates.

Latency

The delay between the time a device receives a packet and the time the packet is forwarded out of the destination port.

Line Speed

See baud rate.

Main Port

The port in a resilient link that carries data traffic in normal operating conditions.

MDI

Medium Dependent Interface. An Ethernet port connection where the transmitter of one device is connected to the receiver of another device.

22

Image 22
Contents Page Preface Revision DateTable of Contents Safety Instructions Safety CautionsEnglish Protecting Against Electrostatic Discharge Setup IntroductionFast Ethernet Technology Gigabit Ethernet Technology802.1p Priority Tagging Switching TechnologyJumbo Frame Support Features Hardware Overview Top Panel LEDsLink/Act/Speed Power IndicatorCable Diagnostics − LED Indications Open, Short, or Improper TerminationRear Panel Connections Power JackAuto MDI/MDI-X Ports Installation Before You Connect to the NetworkMounting on a cement wall Mounting the Switch on the WallMounting on a wood wall Connecting To Network Backbone or Server Connecting the SwitchHub/Switch to DGS-1005G DGS-1005G to End NodeTroubleshooting Does the DGS-1005G switch have an uplink port?Networking Basics Check your IP addressStatically Assign an IP address StepGlossary Bootp CSMA/CDLAN IPXMDI Rmon MDI-XMIB RPSUDP TCP/IPTftp VlanTechnical Specifications EMIPacket Filtering / Forwarding Rate RJ-45 Pin SpecificationsMAC Address Learning Phone Support Contacting Technical SupportInternet Support Registration