D-Link DGS-1248T manual Front Panel, LED Indicator, Reset, 1000BASE-T Twisted Pair Ports Port 1~48

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators of the Switch.

Front Panel

The figure below shows the front panels of the Switch. 10/100/1000 Base-T Twisted-Pair Ports w/ LED Indicators

┌─────────────────────────────┐

└──┘

SFP(Mini GBIC) Ports

Figure 4. Front panel of 48-Port Gigabit Ethernet Switch

LED Indicator

Comprehensive LED indicators display the status of the Switch and the network (see the LED Indicators chapter below).

1000BASE-T Twisted Pair Ports (Port 1~48)

The DGS-1248T is equipped with fourty-eight Gigabit twisted pair ports that are auto negotiable 10/100/1000Mbps and also support auto MDI/MDIX crossover detection. These ports can operate in half- and full-duplex modes.

SFP(Mini GBIC) Ports (Option Port 45~48)

The Switch is equipped with Four SFP(Mini GBIC) ports, supporting optional 1000BASE-X SFP(Mini GBIC) transceivers.

Note: When the port is set to “Forced Mode”, Auto MDI/MDIX will be disabled.

Reset

The Reset button is used to reset all settings back to the factory defaults.

Note: Be sure that you record the settings of your device, or else all settings will be erased when pressing the “Reset” button.

9