In the “Option TAB”, there is the Refresh Time function. This function helps you to refresh the time for monitoring the device. Choose 15 secs, 30 secs, 1 min, 2 min, and 5 min to select the time for monitoring.
In the “Help TAB”, there is About function, it will show out the version of the Web Management Utility.
Configuring the Switch
The Web Smart
Port Setting (Speed/Disable and Flow Control)
Virtual LAN Group setting (VLAN)
Trunk
Port Mirroring
QoS
SNMP
Jumbo Frame
System Setting
Device status and Statistics
Login
Before you configure this device, note that when the Web Smart Switch is configured through an Ethernet connection, make sure the manager PC is set on same the IP network. For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter the IP address http://192.168.0.1 (the
Figure 13.
18