D-Link DGS-1248T manual Jumbo Frame Setting, QoS Setting

Page 37

Modify Trap: To modify previously defined SNMP Trap, click on the ID parameter to enter to the selected SNMP Trap to configure its community name, IP address and events. Press “Apply” to save change of the SNMP Trap.

Figure 32. Modify SNMP Trap

Jumbo Frame Setting

To enable or disable the Jumbo Frame function on the Switch.

Figure 33. Jumbo frame setting

QoS Setting

To set the Switch QoS base on IEEE 802.1p,

Figure 34. 802.1P-based QoS Setting

32

Image 37

Contents Manual Page Vcci Warning Iii Table of Content Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyVlan Virtual Local Area Network FeaturesPage Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network CableReset LED IndicatorFront Panel 1000BASE-T Twisted Pair Ports Port 1~48Rear Panel AC Power ConnectorPower System Power Indicator Power and System LEDsCPU Management Indicator Ports 1~48 Status LEDsSpeed Mini-GBIC Port 45F ~ 48F LEDsLink/ACT Configuration Installing the Web Management UtilityMonitor List Discovery ListPage Configuration Setting Device SettingToolbar Login Configuring the SwitchDevice Status Configuring Setup Setting Setup MenuPort Setting Port SettingsDefault Priority Speed/DisableVlan Settings Virtual Local Area Network Flow ControlVID Table Setting Port VID SettingTrunk Setting Port Egress SettingMirror Setting Mirror SettingSpanning Tree Setting Spanning Tree SettingPage Traps Snmp SettingMIBs Configure Snmp CommunityDelete Snmp Community group Configure Snmp TrapAdd Snmp Trap QoS Setting Jumbo Frame SettingDevice Status Statistics Port Statistic System Setting Abnormal* 50 error packet count within 10 seconds Trap SettingBackup Setting Password SettingLogout Reset SettingTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA