D-Link DGS-1248T manual Rear Panel, AC Power Connector

Page 15

Rear Panel

Figure 5. Rear panel of the Switch

AC Power Connector:

This is a three-pronged connector that supports the power cord. Plug in the female connector of the provided power cord into this connector, and the male into a power outlet. Supported input voltages range from 100-240V AC at 50-60Hz.

10

Image 15

Contents Manual Page Vcci Warning Iii Table of Content Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyVlan Virtual Local Area Network FeaturesPage Unpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAC Power Connecting Network Cable1000BASE-T Twisted Pair Ports Port 1~48 LED IndicatorReset Front PanelRear Panel AC Power ConnectorPorts 1~48 Status LEDs Power and System LEDsPower System Power Indicator CPU Management IndicatorMini-GBIC Port 45F ~ 48F LEDs SpeedLink/ACT Configuration Installing the Web Management UtilityMonitor List Discovery ListPage Configuration Setting Device SettingToolbar Login Configuring the SwitchDevice Status Configuring Setup Setting Setup MenuPort Setting Port SettingsFlow Control Speed/DisableDefault Priority Vlan Settings Virtual Local Area NetworkVID Table Setting Port VID SettingTrunk Setting Port Egress SettingMirror Setting Mirror SettingSpanning Tree Setting Spanning Tree SettingPage Traps Snmp SettingMIBs Configure Snmp CommunityDelete Snmp Community group Configure Snmp TrapAdd Snmp Trap QoS Setting Jumbo Frame SettingDevice Status Statistics Port Statistic System Setting Abnormal* 50 error packet count within 10 seconds Trap SettingBackup Setting Password SettingLogout Reset SettingTechnical Specifications Performance Page Page Product Registration International Offices Registration Card All Countries and Regions Excluding USA