Altinex MT105-120/121 manual General, Installation, Cleaning, FCC / CE Notice

Page 3

MULTI-TASKER™

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your MT105-120/121. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT105-120/121and to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1 GENERAL

Qualified ALTINEX service personnel, or their authorized representatives must perform all service.

1.2 INSTALLATION

To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the MT105-120/121in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

Handle the MT105-120/121carefully. Dropping or jarring can damage the card.

Do not pull the cables that are attached to the

MT105-120/121.

Insert the card carefully into the slots of the Multi-Tasker™ without bending any edges.

1.3 CLEANING

Clean only the connector area with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the card. Do not clean or touch any component or PCB.

1.4 FCC / CE NOTICE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

400-0362-003

2

Image 3
Contents MT105-120/121 Table of Contents MT105-120/121 InstallationCleaning GeneralAbout Your MULTI-TASKER Technical Specifications MT105-120 Front Panel Diagram 1 Typical Setup Diagram 2 MT105-120 Internal View Diagram 3 MT105-121 Internal View Description of Commands RS-232 Control1 RS-232 Interface VER CnS?CnUi STA +MA+ON Sigo SDLSDLm=s SigiFeedback Operation 10. onSingle Card Operation Path OperationOFF Group OperationOFF1C6P OFF3C7P 14. …P Path 16. IOCLR 21. WR MATmXnCiTest HelpRMC RMG24. RD Clrg CLMG1=EMPTY Menu Mode Menu Command DefinitionsUsing Menu Mode 4 MT105-120/121 Menus Menu TypesESC GO Back KEY= SET Matrix Config Save this SETTING?Reset Card to Factory Default Switch IN-OUT Enter a NumberTurn OFF Output Menu Mode ExamplesSet Sync Delay for Output 1 to 2 seconds Connect Input 2 to OutputLimited WARRANTY/RETURN Policy Card is not RecognizedNo Display