Altinex MT105-120/121 manual Ver, CnS, ?CnUi

MULTI-TASKER™

1.[VER]

This command displays the software version and card type for the MT105-120/121card.

Command Format: [VERCnUi]

Cn = Card ID (n = slot # from 1 to max slots)

Ui = Unit ID (i = # from 0 to 9)

Example:

An MT105-120card is in slot #4. Send the command [VERC4], and the Multi-Tasker™ Enclosure will return the following feedback:

MT105-120 690-0170-003

MT105-120 = the card model

690-0170-003 = the software version

2.[C]

This command displays the status of the card and connections of the Matrix Switcher.

Command Format: [CnUi]

Cn = Card ID (n = slot # from 1 to max slots)

Ui = Unit ID (i = # from 0 to 9)

Example:

An MT105-120card is in slot #4. Outputs 1, 2 and 3 are ON. Input 1 is connected to Output 1. Input 2 is connected to all the remaining outputs.

Sending the command [C4] will yield the following feedback:

Matrix:8X8

In1-Out1 ON

In2-Out2 ON

In2-Out3 ON

In2-Out4 OFF

In2-Out5 OFF

In2-Out6 OFF

In2-Out7 OFF

In2-Out8 OFF

If there is no card in slot #4, sending the [C4] command will not return any feedback.

3.[CnS]

This command saves the input to output settings, as well as, the ON/OFF status of each output. This configuration will be restored after the system is reset or powered off then on.

Cn = Card ID (n = slot # from 1 to max slots)

Ui = Unit ID (i = # from 0 to 9)

Example:

There is an MT105-120in slot #4. Input 1 is connected to all outputs, but only outputs 1 through 3 are ON. The feedback after sending the command [C4S] would be:

Matrix:8X8

In1-Out1 ON

In1-Out2 ON

In1-Out3 ON

In1-Out4 OFF

In1-Out5 OFF

In1-Out6 OFF

In1-Out7 OFF

In1-Out8 OFF

Saved

4.[?CnUi]

This command will return general information about the card and its status. It is a function of both the card and the front panel and is only available with Multi-Tasker™ Front Panel systems that have the following firmware:

690-0122-015 = Version 015 or later.

690-0123-004 = Version 004 or later.

690-0124-018 = Version 018 or later.

NOTE: In MTSetup™, send the command [VER] from the Terminal Window. The system will respond with feedback similar to the following:

[690-0122-015 690-0123-004 690-0124-018]

400-0362-003 9