Patch | 19 |
PCR: 40249 Module: SWI, SWMX
Fibre SFPs can now be set to a fixed speed. Copper SFPs still can not have their speed parameters modified.
PCR: 40270 | Module: PIM6 |
The maximum number of PIM6 interfaces has been increased from 255 to 2000. The number of MLD interfaces has also been increased to 2000 to match the maximum number of PIM interfaces.
PCR: 40274 Module: VLAN, RMON | Level: 3 |
In SNMPv2c the histroyControlBucketsGranted value was outside the acceptable range. This issue has been resolved.
PCR: 40277 | Module: IPG | Level: 2 |
BGP routes were not always readvertised to peers after a
PCR: 40289 | Module: IPG, IPV6 | Level: 2 |
The device’s own MAC address was accepted as the next hop MAC address when adding a static IP ARP entry with the add ip arp command, or an IPv6 neighbour with the add ipv6 nd command. This issue has been resolved.
PCR: 40290 | Module: IPG | Level: 3 |
An incorrect nexthop for a RIP route was advertised in RIP messages. This issue has been resolved.
PCR: 40299 | Module: IPG | Level: 2 |
When the most recently added VLAN was deleted, the switch did not respond correctly to subsequent DHCP Discover messages. This issue has been resolved.
PCR: 40301 | Module: SWMX | Level: 3 |
The value for the Device rule space limit in the output of the show switch | ||
command was incorrect. This issue has been resolved. |
| |
PCR: 40302 | Module: SWI, SWNP | Level: 3 |
Incorrect options were returned with “?” help for the show switch |
| |
accelerator command. This issue has been resolved. |
| |
PCR: 40307 | Module: SSL | Level: 2 |
A memory leak sometimes occurred when many HTTPS sessions (using
SSL) were load balanced. This issue has been resolved.
PCR: 40310 | Module: IPV6 | Level: 3 |
The incorrect parameter ipaddress was returned with “?” help for the delete ipv6 host=name command. This issue has been resolved.
PCR: 40312 | Module: IPV6 | Level: 2 |
IPv6 packets travelling through a
Patch