Patch | 9 |
PCR: 40562 Module: SWNP | Level: 2 |
If the command enable switch accelerator function=icmpredirect had been executed, there was no resulting entry in a script subsequently created by the create config or show config dynamic commands. This issue has been resolved.
PCR: 40565 Module: SWMX | Level: 2 |
If two protocol VLAN association rules were added to two different VLANs, the second protocol association rule would not work. This issue has been resolved.
PCR: 40571 Module: SWMX | Level: 2 |
When PIM or DVMRP was enabled, if IP multicast packets were received on the
PCR: 40574 Module: SWMX | Level: 2 |
Adding, or deleting, port=42 to, or from, a VLAN could cause the entire
Layer 2 Multicast Table to be cleared. This would subsequently cause high
CPU utilisation under heavy multicast traffic. This issue has been resolved.
PCR: 40586 Module: SWMX | Level: 2 |
If VRRP had been enabled on the switch, then the routing of any packets that entered the switch via a an interface on which VRRP was operating would be performed in software, rather than using the L3 switching process in the ASIC. This issue has been resolved.
PCR: 40592 Module: BOOTP | Level: 2 |
If a
Level 3
PCR: 40471 | Module: SWI | Level: 3 |
When an accelerator card is installed, and ports had been configured for mirroring, the enable switch mirror caused an unnecessary warning message to be displayed. This issue has been resolved.
PCR: 40474 | Module: IPG | Level: 3 |
When an accelerator card is installed, the set switch mirror command caused the switch to display an incorrect message saying that the maximum port number is 54. This issue has been resolved.
PCR: 40493 Module: DHCP | Level: 3 |
In certain scenarios when acting as a DHCP server, the switch would send a DHCP ACK to an invalid MAC address. This issue has been resolved.
Patch