32 | add ip filter | Patch Release Note |
add ip filter
Syntax ADD IP
SOurce=ipadd [SMask=ipadd]
Description This command adds a pattern to a routing filter. For details about the command parameters, see Table 12 on page 32.
Table 12: Parameters for the BGP route import feature in the add ip filter command.
Parameter |
| Option/Range | Description |
|
|
|
|
300...399 | Filters in the range 300 to 399 are treated as routing filters, and use the action | ||
|
|
| parameter to specify the action to take with a route that matches the pattern. |
|
|
|
|
ACTion |
|
| The action to take when the filter pattern is matched. |
|
|
|
|
|
| INCLude | Route information matching the filter will be included. |
|
|
|
|
|
| EXCLude | Route information matching the filter will be excluded. |
|
|
|
|
SOurce |
|
| The source IP address, in dotted decimal notation, for the filter pattern. |
|
|
|
|
SMask |
|
| The mask, in dotted decimal notation, to apply to source addresses for this pattern. |
|
|
| The mask is used to determine the portion of the source IP address in the IP packet |
|
|
| that is significant for comparison with this pattern. The values of source and smask |
|
|
| must be compatible. For each bit in smask which is set to zero (0) the equivalent bit |
|
|
| in source must also be zero (0). If source is not 0.0.0.0, then smask can not be |
|
|
| 0.0.0.0. The default is 255.255.255.255, unless source is 0.0.0.0. |
|
|
| |
ENTry |
| The entry parameter specifies the entry number in the filter which this new pattern | |
|
|
| occupy. Existing patterns with the same or higher entry numbers are pushed down |
|
|
| the filter. The default is to add the new pattern to the end of the filter. |
*Caps denote command shortcuts
Availability
Patches can be downloaded from the Software Updates area of the Allied Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html. A licence or password is not required to use a patch.
Patch