Allied Telesis GS900/5E manual Installing the Switch in a Rack, Attaching Rackmounting Brackets

Page 32

Chapter 2: Installation

Installing the Switch in a Rack

Perform the following procedure to install the switch in a standard 19-inch rack. If you are not installing the switch in a rack, go to the next procedure.

1.Place the unit upside down on a level, secure surface.

2.Using a flat-head screwdriver, remove the self-adhesive rubber feet from the bottom of the switch, as shown in Figure 9.

Figure 9. Removing the Feet

3.Turn the switch over.

4.Attach the two rackmounting brackets (provided) to the sides of the switch using the eight flathead Phillips screws (provided), as illustrated in Figure 10.

605

Figure 10. Attaching Rackmounting Brackets

32

Image 32
Contents Installation Guide Page Electrical Safety and Emissions Standards Translated Safety Statements Contents Contents Preface Safety Symbols Used in this Document Symbol Meaning DescriptionWhere to Find Web-based Guides Warranty Contacting Allied TelesisManagement Software Updates Product Description ChapterFeatures StandardsComponents Front PanelsHardware Feature Description Twisted Pair PortsMaximum Distance AC Power Connector Ethernet Switching Basics MAC Address TableDuplex Mode Store Forward Power Workgroup Topology Network TopologiesCollapsed Backbone Installation Reviewing Safety Precautions Selecting a Site for the Switch Planning the Installation Speed Type of Cable MaximumUnpacking the Switch Installing the Switch on a Table or Desktop Installation Installing the Switch on a Wall Attaching the brackets to the sides of the switch1303 Page Installing the Switch in a Rack Attaching Rackmounting Brackets606 Installation Cabling the Switch Powering On the Switch Troubleshooting Technical Specifications Physical SpecificationsEnvironmental Specifications Power SpecificationsCompliance Standards Safety and Electromagnetic Emissions CertificationsRJ-45 Twisted Pair Port Connectors Pin Signal