Allied Telesis GS900/5E manual Powering On the Switch

Page 36

Chapter 2: Installation

Powering On the Switch

To apply power to the AT-GS900/16 and AT-GS900/24 switches, perform the following procedure:

1.Apply AC power to the switch by plugging the power cord into the AC power connector on the back panel of the unit, as illustrated in Figure 13.

Warning

Power cord is used as a disconnection device: To de-energize equipment, disconnect the power cord. E3

100-	VAC~

612

Figure 13. Connecting the AC Power Connector to Switch

2.Plug the other end or the power cord into a wall outlet.

3.Verify that the POWER LED is green. If the LED is OFF, refer to “Troubleshooting” on page 37.

The switch is ready for network operations.

36

Image 36

Contents Installation Guide Page Electrical Safety and Emissions Standards Translated Safety Statements Contents Contents Preface Safety Symbols Used in this Document Symbol Meaning DescriptionWhere to Find Web-based Guides Warranty Contacting Allied TelesisManagement Software Updates Product Description ChapterFeatures StandardsComponents Front PanelsHardware Feature Description Twisted Pair PortsMaximum Distance AC Power Connector Ethernet Switching Basics MAC Address TableDuplex Mode Store Forward Power Workgroup Topology Network TopologiesCollapsed Backbone Installation Reviewing Safety Precautions Selecting a Site for the Switch Planning the Installation Speed Type of Cable MaximumUnpacking the Switch Installing the Switch on a Table or Desktop Installation Installing the Switch on a Wall Attaching the brackets to the sides of the switch1303 Page Installing the Switch in a Rack Attaching Rackmounting Brackets606 Installation Cabling the Switch Powering On the Switch Troubleshooting Technical Specifications Physical SpecificationsEnvironmental Specifications Power SpecificationsSafety and Electromagnetic Emissions Certifications RJ-45 Twisted Pair Port ConnectorsCompliance Standards Pin Signal