Aastra Telecom ATP-CNX-020 setup guide Configuring Domain Name Service DNS

Aastra CNX Quick Installation and Setup Guide

Procedures

Step	Action
6	Enter “y” if the network information is correct, and press <Enter>.
	Enter “n” if the network information is incorrect, and press <Enter>.
	Note: If you entered “n” at the verification prompt, repeat steps 3 through 7 to correct the network
	information, and then enter “y” at step 8.
	The following message and prompt display (after entering “y” at the verification prompt):
	Configuring Domain Name Service (DNS)...
	Domain Name:
7	Enter the Default Gateway for the Ethernet port for which you want to use as a management
	interface, and press <Enter>. For example:
	Default Gateway: 192.168.2.1 ↵
	The following displays:
	Before the following information is configured, please verify the
	information below is correct before proceeding.
	Hostname:	cnx1
	IP Address:	192.168.2.6
	Broadcast Address:	192.168.2.255
	Netmask:	255.255.255.0
	Default Gateway:	192.168.2.1
	Is this correct (y/n):
8	Enter “y” if the network information is correct, and press <Enter>.
	Enter “n” if the network information is incorrect, and press <Enter>.
	Note: If you entered “n” at the verification prompt, repeat steps 3 through 7 to correct the network
	information, and then enter “y” at step 8.
	The following message and prompt display (after entering “y” at the verification prompt):
	Configuring Domain Name Service (DNS)...
	Domain Name:
		(continued)

10 ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06