EtherHub 1500 System User’s Guide
Parameter
Hub ID
Position
Port Identifier
Name
Type
Status
Part
Link State
Configuring Port Parameters
Use the Port command from the Control menu to configure the ports for any hub in the stack. (Select the required hub using the <F4> and <F5> function keys.) This menu provides a brief description of the selected hub, and also allows you to enable/disable any port in the selected hub.
Description
Hub identifier within the stack.
The physical position in the stack.
Numeric identifier 1~16 or ALT.
Connection types include
Any port may ENABLED or DISABLED.
Indicates if the port is partitioned.
Indicates if the port has a valid connection to an external device.
Parameter
Backup Set
Master Port
Hub
Port
Slave Port
Hub
Port
Defining Backup Ports
Use the Backup Port command in the Control Menu to define up to three master/slave port pairs. If the connection to the master port fails, the slave port will automatically take over.
Description
Defines up to three backup port pairs; each of which can be set to ACTIVE or INACTIVE.
Pair member serving as the primary link.
Hub ID for the master port.
Port identifier for the master port.
Pair member serving as the backup link.
Hub ID for the slave port.
Port identifier for the slave port.
Setup and Configuration |