Adder Technology SmartView warranty ‘HOTKEYs’ and ‘1 then 0’ selects channel

‘HOTKEYs’ and ‘1 then 0’ - selects channel 10	(12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 1’ - selects channel 11	(12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 2’ - selects channel 12	(12 & 16 port models only)
‘HOTKEYs’ and ‘1 then 3’ - selects channel 13	(16 port models only)
‘HOTKEYs’ and ‘1 then 4’ - selects channel 14	(16 port models only)
‘HOTKEYs’ and ‘1 then 5’ - selects channel 15	(16 port models only)
‘HOTKEYs’ and ‘1 then 6’ - selects channel 16	(16 port models only)
‘HOTKEYs’ and ‘TAB’ - selects the next channel

‘HOTKEYs’ and ‘M’ - displays the on screen menu for selecting computers by name

‘HOTKEYs’ and ‘A’ - selects autoscan mode where each channel is displayed for the selected time (see section 4.3). To cancel autoscan mode simply select any fixed channel either by hotkey or using the SmartView button.

‘HOTKEYs’ and ‘0’ – switches off the video signal and displays 0. This will cause some monitors to go into standby mode or switch off. The video signal can be re- enabled by selecting a channel.

‘HOTKEYs’ and ‘L’ - disables the SmartView's shared keyboard and mouse and displays 0. The video signal is switched off. If a password has not been set then the SmartView can be re-enabled by selecting a channel. If a password has been set then the SmartView displays 'P' to indicate that a valid password must be entered to unlock the switch. Simply type the same key combination as was set during configuration (see section 4.8) followed by the (enter) key. Note - if anyone has typed at the keyboard whilst in secure mode, it will be necessary to type (enter) first to clear the invalid password, then type the valid password followed by (enter) again.

‘HOTKEYs’ and ‘0 then {number}’ – (where {number} is 0,1,2,3,4,5,6,7,8 or 9). Selects the channel specified by {number}. This allows ports on cascaded units to be selected. For example HOTKEYs + 0 10216 would select port 1 (01) on the current SmartView, port 2 (02) on the next cascaded SmartView and port 16 on the last SmartView.

SmartView Installation and Use Page 23