RuggedCom RS910L manual Dielectric Strength Testing

Page 11

2.2.3 Dielectric Strength Testing

Units which are to have dielectric strength testing (HIPOT testing) done in the field must have the braided ground cable disconnected during the test. This is required in order to prevent the surge suppression circuitry, which is connected to surge ground, from being activated.

Figure 6 - Dielectric Strength Testing

	11
 2007 RuggedCom Inc. All rights reserved	Rev100

Image 11

Contents RuggedVDSL RS910L Installation GuideTrademarks Table of Contents Table of Figures Functional Overview Feature HighlightsProduct Overview RS910L Front Panel Description RS910L Front Panel DescriptionRS910L Bottom Panel Description RS910L Bottom Panel Description Din Rail Mounting InstallationAC Power Supply Wiring and Grounding Power Supply Wiring and GroundingDC Power supply wiring and grounding diagram DC Power Supply Wiring and GroundingDielectric Strength Testing Dielectric Strength TestingRS910L Failsafe Output Relay Failsafe Output WiringPin Signal RS232 Console Port Wiring2 RS232/RS485/RS422 via DB9 Serial PortsFiber Serial Interface 3 RS232/RS485/RS422 via RJ45 Pin RS232 ModeRJ45 Port pin-out 4 RS485 WiringSerial Port Transient Protection Conceptual recommended RS485 wiring diagramOverview Ethernet PortsRJ11 Ethernet over Vdsl Port Performance WiringConfiguration & Setup RJ45 Ethernet Ports Pin SignalFiber Optic Ethernet Ports 100FX Mtrj connectorEthernet Panel Description 100FX LC connectorOperating Environment Technical SpecificationsPower Supply Specifications Failsafe Relay SpecificationsFiber Optic Ports RJ11 Ethernet over Vdsl Port SpecificationsSerial Ports Copper PortsCommunication Standards Ethernet PortsParameter Value Mechanical SpecificationsIEC 61850-3 Type Tests Type TestsIEC Environmental Type Tests Ieee 1613 Type TestsWarranty