Ranger service manual TR-127GK/DX Operation, Introduction, Controls and Connections Front Panel

Page 4

TR-127GK/DX

CHAPTER 2 OPERATION

910 11 12 13 14 15 16 17 18

 

 

S/RF

 

ANL

NB

CB

TONE

CH19

 

 

 

 

 

 

 

 

 

 

TX/RX

 

 

SWR

 

 

 

 

 

 

 

TR - 127

CAL

 

OFF

OFF

PA

LOW

NORMAL

ANT

 

MIC GAIN

VOL

 

SQ

RF GAIN

 

SWR CAL

CLARIFY

 

 

OFF

 

 

 

 

 

 

 

1

2

 

3

4

5

 

6

7

8

Figure 2-1 Front Panel

2.0 INTRODUCTION

This section explains the basic operating procedures for the TR-127GK or TR-127DX mobile CB radio.

2.1 CONTROLS AND CONNECTIONS

2.1.1 FRONT PANEL

Refer to the above Figure 2-1 for the location of the following controls.

1.MICROPHONE JACK: Used to connect microphone for voice source.

2.MIC GAIN CONTROL: Adjust the microphone gain in the transmit and PA modes. This controls the gain to the extent that full talk power is available several inches away from the microphone. In the Public Address (PA) mode, the control function as the volume control.

3.ON/OFF VOLUME CONTROL: This knob controls the volume and power to the radio. To turn radio on, rotate the knob clockwise. Turning the knob further will increase the volume of the receiver.

4.SQUELCH CONTROL: This knob is used to eliminate background noise being heard through the receiver, which can be disturbing when no transmissions are being heard through the receiver. To use this feature, turn the knob fully counterclockwise and then turn clockwise slowly until the

-3 -

Image 4
Contents TR-127GK/DX TR-127GK/DX Table of Contents TR-127GK/DX Chapter Specifications GeneralIntroduction TR-127GK/DX OperationControls and Connections Front Panel Page Rear Panel Represents the location of the following connectionsFrequency Chart Channel Channel Frequency MHzProcedure to Transmit Operation Procedure to ReceiveMicrophone Alternate Microphones and Installation Your Transceiver Microphone SchematicTR-127GK/DX Chapter Circuit Description PLL CircuitReceiver Circuit Transmitter Modulation CircuitTR-127GK/DX Block Diagram Alignment Procedures PLL Alignment T. Setting Adjust Point MeasurementTR-127GK/DX Chapter Alignment Required Test EquipmentTransmitter Alignment T. Setting Adjust Measurement Point Receiver Alignment T. Setting Adjust Measurement PointTransmitter test setup TR-127GK/DX Main PCB Adjustment Location TR-127GK/DX Chapter Maintenance PrecautionsFuse Replacement Periodic InspectionTR-127GK/DX Chapter Diagrams Parts List GeneralTR-127GK/DX Rotary Switch PCB EPT092920Z Part List Reference Ranger Part Description NumberTR-127GK/DX Display PCB EPT092930Z Reference Ranger Part Description TR-127GK/DX Main PCB EPT012910A Copper Side Part List TR−127GK/DX Main PCB L23 TR-127GK/DX Schematic Diagram TR-127GK Mechanical Part TR-127DX Mechanical Part AT0127040A  Copyright 2004, Ranger Communications, Inc