Microphone, Operation Procedure to Receive

2.2 MICROPHONE

The push-to-talk switch on the microphone controls the receiver and transmitter. Press the switch and the transmitter is activated, release switch to receive. When transmitting, hold the microphone two inches from your mouth and speak clearly in a normal voice. This transceiver comes complete with a low impedance dynamic microphone.

2.3 OPERATION

2.3.1 PROCEDURE TO RECEIVE

1.Be sure that the power source, microphone and antenna are connected to the proper connectors before going to the next step.

2.Turn VOL knob clockwise to apply power to the radio.

3.Set the VOL to a comfortable listening level.

4.Set the MODE switch to the desired mode.

5.Listen to the background noise from the speaker. Turn the SQUELCH knob slowly clockwise until the noise just disappears. The SQUELCH is now properly adjusted. The receiver will remain quiet until a signal is actually received. Do not advance the control too far or some of weaker signals will not be heard.

6.Set the CHANNEL selector switch to the desired channel.

7.Set the RF GAIN control fully clockwise for maximum RF gain.

8.Adjust the CLARIFY control to optimize AM signals.

2.3.2 PROCEDURE TO TRANSMIT

1.Select the desired channel of transmission

2.Set the MIC GAIN control fully clockwise.

3.If the channel is clear, depress the push-to-talk switch on the microphone and speak in a normal voice.

- 7 -