3Com 4210 PWR 18-PORT manual Introduction to the Switch 4210 Family Non-PWR Models, Panel Status

14CHAPTER 1: PRODUCT INTRODUCTION

Table 5 The 1000 Mbps uplink port status LED on 4210 PWR models

	Mark on the
LED	panel	Status	Description

1000 Mbps uplink port ACT active LED

BLINKING	The port is in the active state and
	there is traffic on the port.
OFF	The port is in the active state but
	there is no traffic on the port.

Introduction to the Switch 4210 Family Non-PWR Models

This section describes each Switch 4210 Family model.

Switch 4210 9-port Front panel

The Switch 4210 9-port model provides eight 10/100Base-TX autosensing Ethernet ports, one 10/100/1000Base-T autosensing Ethernet port, one 100/1000Base-X SFP port, and one Console port. The SFP port and the 10/100/1000BASE-T autosensing Ethernet port form a Combo port. For the Combo port, either the SFP port or the 10/100/1000BASE-T Ethernet port can be used at a time.

Figure 10 shows the front panel of the Switch 4210 9-port model.

Figure 10 The Switch 4210 9-port model’s front panel

(1) (2) (3) (4)

	(8) (7)		(7)	(6)	(5)
(1)	10/100Base-TX autosensing port Speed LED (green)
(2)	10/100Base-TX autosensing port	(3) Combo port Speed LED (green)
(4)	10/100/1000Base-T autosensing port	(5)	Console port
(6)	100/1000Base-X SFP port	(7)	Link/Act LED (green)
(8)	Power LED (PWR)

.