Rosewill RPLC-500 user manual Device C will flash unevenly for 2 minutes

Page 22

500Mbps Powerline Gigabit Ethernet Adapter KIT

- RPLC-500KIT-

User’s Manual

 

 

 

 

and Device C will flash unevenly for 2 minutes.

4.2 Using the Utility

Scenario:

Devices A and B are located in Network N. Device C (the joiner) that is located in another network attempts to join Network N. See

Do as follows to add Device C to Network N using the Utility:

1.Connect Device C to the network card of a PC.

2.Open the Utility. The Main tab page displays information about Device C after connection succeeds.

3.Click the Privacy tab page. Enter a name in the Private Network Name field.

4.Click Set Local Device Only. When the page shown as below displayed, the setting success. Now Device C has been removed from its logical network.

5.Press the pushbutton on Device A or B for less than 3 seconds, making it the „adder‟.

6.Within 2 minutes, press the pushbutton on Device C (the „joiner‟) for less than 3 seconds.

7.Wait for connection to complete.

The Power indicator on Device A (or Device B) and Device C will flash at 1 second intervals until the process succeeds or fails. It will illuminate steadily on success. If an error occurs, the Power indicator on Device A (or Device B) and Device C will flash unevenly for 2 minutes.

-22-

Page 21 Page 23
Image 22
Page 21 Page 23
Contents 500Mbps Powerline Gigabit Ethernet Adapter Contents Package Contents Introduction to Hardware Key FeaturesExpanding your Network with RPLC-500 Application  Green Feature for Power saving mode QoS Management Enhances Streaming Quality Hardware Diagram of RPLC-500 System Requirement1 LED Powerline Adapter’s Button and ConnectorColor Behavior Description Utility Installation Introduction to Utility500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT Utility Introduction Main TabDevice Name PasswordMAC Address Add ScanPrivacy Tab Set Local Device OnlyDiagnostics Tab Set All Devices500Mbps Powerline Gigabit Ethernet Adapter KIT Forming a Powerline HomePlug AV Network About TabScenario Using the Security PushbuttonUsing the Utility Forming a HomePlug AV logical networkNetwork name setting success Setting the network name for your PLCSearch for Local device on your computer Joining a Network Joining a networkDevice C will flash unevenly for 2 minutes Appendix B Specifications Appendix a Improving the Transmission QualityPower Consumption Powerline SpeedsPowerline Range DimensionsAppendix D RPLC-500 QoS Support Appendix C Acronyms and AbbreviationsCCo Default CAP Vlan Tag User Default CAP TOS Bit User PriorityCopyright & Trademarks
Top Page Image Contents