Rosewill RPLC-500 user manual Using the Security Pushbutton, Using the Utility, Scenario

Page 19

500Mbps Powerline Gigabit Ethernet Adapter KIT

- RPLC-500KIT-

User’s Manual

 

 

 

 

3.1 Using the Security Pushbutton

Scenario:

Devices A and B with different NMK (Network Membership Key used to authenticate/access) values are connected to the same powerline. Users want to use them to form a logical network.

Forming a HomePlug AV logical network

Please follow below steps to form a logical network using the Security button:

1.Press the Security button on Device A for less than 3 seconds.

2.Press the Security button on Device B for less than 3 seconds. The button on B must be pressed within 2 minutes

3.Wait for connection to complete.

The Power indicator on both devices will flash evenly at 1 second interval until the operation succeeds or fails. The Power indicator will illuminate steadily on successful completion. If an error occurs, the Power indicator on both devices will flash unevenly for 2 minutes.

3.2 Using the Utility

Scenario:

Devices A and B are located in different networks. Users want to use them to form a logical network.

In this case, using the Security pushbutton cannot pair Devices A and B. Users can only use the Utility to form a logical network.

-19-

Page 18 Page 20
Image 19
Page 18 Page 20
Contents 500Mbps Powerline Gigabit Ethernet Adapter Contents Package Contents Introduction to Hardware Key FeaturesExpanding your Network with RPLC-500 Application  Green Feature for Power saving mode QoS Management Enhances Streaming Quality System Requirement Hardware Diagram of RPLC-5001 LED Powerline Adapter’s Button and ConnectorColor Behavior Description Introduction to Utility Utility Installation500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT Main Tab Utility IntroductionDevice Name PasswordMAC Address Scan AddSet Local Device Only Privacy TabSet All Devices Diagnostics Tab500Mbps Powerline Gigabit Ethernet Adapter KIT About Tab Forming a Powerline HomePlug AV NetworkForming a HomePlug AV logical network Using the Security PushbuttonUsing the Utility ScenarioNetwork name setting success Setting the network name for your PLCSearch for Local device on your computer Joining a network Joining a NetworkDevice C will flash unevenly for 2 minutes Appendix a Improving the Transmission Quality Appendix B SpecificationsDimensions Powerline SpeedsPowerline Range Power ConsumptionAppendix D RPLC-500 QoS Support Appendix C Acronyms and AbbreviationsCCo Vlan Tag User Default CAP TOS Bit User Priority Default CAPCopyright & Trademarks
Top Page Image Contents