USING THE CALLING-FREQUENCY MEMORY
The
1.Press C to display the current calling frequency.
2.To change the frequency, hold down C until flash.
and C
3.Select a frequency. See “Selecting Frequencies (Direct Tuning)” on Page 23.
4.Press C to store the selected frequency in memory.
5.To enter a frequency offset for repeater operation, press FUNC+SC. The
6.To select the offset direction (+ or
Note: While and C appear, you can program other set- tings such as CTCSS tones (see “Continuous Tone Coded Squelch System Features” on Page 35.)
To enable the calling frequency, press C at any time. The trans- ceiver immediately tunes to that frequency with the settings you programmed. To exit the calling frequency mode, press C again.
31