Rosewill RPLC-500 user manual Add, Scan

Page 14

500Mbps Powerline Gigabit Ethernet Adapter KIT

- RPLC-500KIT-

User’s Manual

 

 

 

 

password in any case formats, with or without dash.

A confirmation box appears if the password is entered correctly. If a device is not found, a message appears, providing suggestions to solve the common problems. This process might take a few seconds to get completed.

Add

This button is used to add a remote device to the existing network by entering the device password of the device. A dialog box will appears. You can enter a device name and the password. (Also refers as DEK on the back Label, this DEK is generates via MAC address)

If the device is found and the password is entered correctly, a confirmation box appears. If a device is not found, a message appears, providing suggestions to solve the common problems.

Note:

The device must be in the powerline (plugged in), so that you can confirm the password and add the device to the network. If the device is not located, a warning message appears.

Scan

This button is used to perform an immediate search for HomePlugAV

-14-

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 500Mbps Powerline Gigabit Ethernet Adapter Contents Package Contents Expanding your Network with RPLC-500 Key FeaturesIntroduction to Hardware  QoS Management Enhances Streaming Quality  Green Feature for Power saving modeApplication Hardware Diagram of RPLC-500 System RequirementColor Behavior Description Powerline Adapter’s Button and Connector1 LED Utility Installation Introduction to Utility500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT 500Mbps Powerline Gigabit Ethernet Adapter KIT Utility Introduction Main TabMAC Address PasswordDevice Name Add ScanPrivacy Tab Set Local Device OnlyDiagnostics Tab Set All Devices500Mbps Powerline Gigabit Ethernet Adapter KIT Forming a Powerline HomePlug AV Network About TabScenario Using the Security PushbuttonUsing the Utility Forming a HomePlug AV logical networkSearch for Local device on your computer Setting the network name for your PLCNetwork name setting success Joining a Network Joining a networkDevice C will flash unevenly for 2 minutes Appendix B Specifications Appendix a Improving the Transmission QualityPower Consumption Powerline SpeedsPowerline Range DimensionsCCo Appendix C Acronyms and AbbreviationsAppendix D RPLC-500 QoS Support Default CAP Vlan Tag User Default CAP TOS Bit User PriorityCopyright & Trademarks
Top Page Image Contents