Silicon Laboratories SI4734/35-B20 manual Parameter Symbol Min Typ Max Unit, Rst, GPO1, GPO2/INT

Si4734/35-B20

Table 4. Reset Timing Characteristics1,2,3 (VDD = 2.7 to 5.5 V, VIO = 1.5 to 3.6 V, TA = –20 to 85 °C)

Parameter						Symbol	Min	Typ	Max	Unit
			Setup to		↑4	tSRST	100	—	—	µs
RST	Pulse Width and GPO1, GPO2/INT			RST
						tHRST
GPO1, GPO2/INT		Hold from RST↑					30	—	—	ns

Important Notes:

1.When selecting 2-wire mode, the user must ensure that a 2-wire start condition (falling edge of SDIO while SCLK is high) does not occur within 300 ns before the rising edge of RST.

2.When selecting 2-wire mode, the user must ensure that SCLK is high during the rising edge of RST, and stays high until after the first start condition.

3.When selecting 3-wire or SPI modes, the user must ensure that a rising edge of SCLK does not occur within 300 ns before the rising edge of RST.

4.If GPO1 and GPO2 are actively driven by the user, then minimum tSRST is only 30 ns. If GPO1 or GPO2 is hi-Z, then minimum tSRST is 100 µs, to provide time for on-chip 1 MΩ devices (active while RST is low) to pull GPO1 high and GPO2 low.

RST

GPO1

GPO2/

INT

70%

30%

70%

30%

70%

30%

tSRST tHRST

Figure 1. Reset Timing Parameters for Busmode Select

6 Rev. 1.0