INSTALLATION
Switch Installation – Single Unit
Please refer to the safety section before installation
The basic installation of a single UltraMatrix switch is an easy and straightforward procedure. Perform the below steps for all computers that will be connected. It is recommended that all computers be powered off. When a computer is connected and then booted, the UltraMatrix will automatically determine the keyboard and mouse types used for that computer and no
CPU KVM
Cable Cable
PC’s
(1 of 16)
KVM Station (1 of 4)
Figure 3. Single Unit configuration
The Unit in Figure 3 can be any UltraMatrix 2xE or 4xE model
If removing power from a computer is not practical, pre-configure the UltraMatrix to define that CPU port’s keyboard and mouse types. This procedure should only be done if the CPUs keyboard and mouse can be disconnected and re-connected without affecting the interface.
The default keyboard type is PC mode 2, and the default mouse type is PS/2. If the computer being connected, with power applied, uses a PC2 keyboard and PS/2 mouse, no pre-configuration is needed. If not, pre-configure the keyboard and mouse types for that CPU port before connecting the computer (steps 4a-4f).
ULTRAMATRIX E-SERIES MANUAL
11