e.Next, select “Starting computer number” and press [Enter]. An input box will display for a new starting computer number. Enter the correct “Starting computer” number for this Unit (See page 15) and press [Enter].
f.Press the “Esc” key to return to the “Main menu”.
g.Select “Save” and press [Enter]. A “YES/NO” choice box will display. Select “YES” and press [Enter] to save the change to flash memory.
h.Turn the power off on the UltraMatrix.
i.Move the KVM station from Unit #2 to Unit #3 and connect it to the KVM #1 connector.
j.Configure this Units “Starting computer” number and then all other Units in the system. When the “Starting computer” number has been entered for all Units, proceed to step 3.
3.Connect a KVM station to Unit #1’s KVM #1 connector and apply power to the monitor and Unit #1.
4.Enter the “Maximum computers” number by:
a.Display the main menu. (Left control [Ctrl] key, then F12 key).
b.Select “System” and press [Enter].
c.Select “Maximum computers” and press [Enter]. An input box will display for a new “Maximum computers” number. Enter the correct “Maximum computers” value as explained on page 15 and press [Enter].
d.Press the “Esc” key to return to the main menu, select “Save” and press [Enter]. A YES/NO choice box will display. Select “YES” and press [Enter] to save the change.
5.Call up the system status display (left [Ctrl] key, then the F12 key).
6.Select “Status” from the main menu and press [Enter]. The system status screen will display showing the following; (Figure 14)
1.Computers
2.Power (Power on status)
3.POS (Card position)
4.VER (Program version)
5.KVM
6.CPU
7.User
8.Status
The number of system CPU ports that Unit #1 has will be highlighted. If the unit is a
(NOTE: System CPU ports = total RS/232 ports times 4)
7.Apply power to the next unit to bus in, then connect an expansion cable (IN THIS ORDER);
From: Unit #2’s lower “OUT” expansion card connector,
To: Unit #1’s lower “IN” expansion card connector.
ULTRAMATRIX E-SERIES MANUAL
23