OPERATION
User operating instructions
The following instructions apply to all UltraMatrix switches.
This section explains the operating functions of the
To start using your UltraMatrix switch, you first need to become familiar with the keyboard commands. The available keyboard commands are shown in Table 1. All keyboard commands start with an attention sequence by pressing and releasing the left [Ctrl] key, then the additional command characters. The additional command characters must be entered within two seconds of each other or the command is aborted.
Commands are not case sensitive and are shown in upper or lower case for clarity only. Do not use the [SHIFT] key or the numeric keypad to enter any commands. [Ctrl] in Table 1’s, Key Sequence column is a press and release function of the left [Ctrl] key.
Keyboard commands
Command | Key Sequence | Description | |
Main Menu | [Ctrl] | [F12] | Displays main menu |
|
|
|
|
CPU List | [Ctrl] | [Esc] | Displays CPU selection list |
|
|
|
|
Direct CPU | [Ctrl] | n [Enter] | Connects directly to the specific |
connect |
|
| CPU number “n”. |
|
|
|
|
Connect Back | [Ctrl] | [Backspace] | Connects to the previous CPU |
|
|
|
|
Connect Down | [Ctrl] | [Minus sign] | Connects to the previous CPU |
|
|
| in a Group. |
|
|
|
|
Connect Up | [Ctrl] | [Plus sign] | Connects to the next sequential |
|
|
| CPU in a group |
|
|
|
|
KVM Status | [Ctrl] | D | Displays / Removes status box. |
|
|
| |
Logout | [Ctrl] L | Logs user out if the KVM station | |
|
|
| is configured for user logins. |
|
|
| |
Disconnect | [Ctrl] Q | Disconnects the current CPU | |
Reset | [Ctrl] R | Resets / enables keyboard and | |
Keyboard/ |
|
| mouse; enables PS/2 mouse on |
mouse |
|
| connected CPU |
|
|
|
|
|
|
|
|
ULTRAMATRIX E-SERIES MANUAL
45