PowerDsine PD-6548 manual About the Power over Ethernet Midspan, Power Management

Page 10

PD-6548

2 About the Power over Ethernet Midspan

PowerDsine’s Midspans family, injects DC power over data-carrying Ethernet cabling. The PD-6548 Midspan, supports 48 ports in a 10/100BaseTx Ethernet network, over TIA/EIA-568 Category 5/5e/6 cabling. DC operating power, for data terminal units, is fed over the unused pairs of the cabling (7/8 and 4/5).

The Midspan powers devices that are Power over Ethernet enabled, or are equipped to receive power over Ethernet. These devices are called Powered Devices (PDs). Devices that are not equipped to receive power over Ethernet, may require an external power adapter in order to be powered. Contact PowerDsine for such an adapter.

The Power over Ethernet Midspan main features are as follows:

„Remote power feeding over standard Ethernet ports

„Eliminates the need for AC outlets, local UPS & AC/DC adapters near PDs

„Universal range power input (100-240 VAC, 50/60 Hz)

„Power management

„Remote Web manager (optional)

„Overload and short-circuit protection per channel

„Port status indications

„Standard 19-inch rack mountable

2.1Power Management

When establishing a network, the total power required by PDs may exceed the total power available from the Midspan. The built-in Power Management feature does not allow the total power output to exceed the maximum power available (refer to the Technical Specifications). When the total power available is close to the maximum value, attempts to connect an additional PD to a free port cause the corresponding port LED to blink green at an 0.5 sec. rate, indicating an out-of-power budget, thus, this port will not deliver power. The power distribution method is based on “First Come, First Served” logic.

Sometimes, connected operating PDs significantly increase or suddenly raise their power requirements. If the required power exceeds the available power, the Power over Ethernet Midspan starts to turn off ports in accordance with their priority (the first turned off port is the lower priority port) until the total power is once again under the maximum limit. Default priority is establishid by port number: the higher the port number is, the lower priority it gets.

Power over Ethernet Solutions

10

Cat. No.: 06-6860-056

Image 10
Contents Power over Ethernet Midspans User GuidePD-6548 Power over Ethernet Solutions Disclaimer PD-6548Contents List of Figures List of TablesPD-6548 Model Numbers Definition Verifying Kit ContentsSafety Standard Approvals Electrical Compatibility ApprovalsAbbreviations Safety Information General GuidelinesPower Cord A. and Canada Denmark Switzerland France PeruAbout the Power over Ethernet Midspan Power ManagementPower over Ethernet Midspan, Front View 10/100BASE-TX Ports DefinitionIndicators Primary Power IndicatorsPower Status Indications Port Status IndicationsConnectors Console Ethernet ConnectorDescription PD-6548 Console Cable D-type ConnectorRear Panel RJ45 Input Plug Per Channel Connecting to the Midspan Power over Ethernet Solutions PD-6548 Front Panel RJ45 Output Plug per channelInstalling the Power over Ethernet Midspan BackgroundRack Mounting Brackets Routing the Input Ports Cables Chasis ‘Ears’Cable Connections Assembling Midspan to Rack Connecting Power Cables Connecting Data CablesPowering up Troubleshooting Troubleshooting StepsPD-6548 Troubleshooting Steps Technical Specifications Physical SpecificationsRemote Web Management Management DeploymentPD-6548 Power over Ethernet Solutions Part Number Rev