Quantum 890 USE 155 manual Setting the Serial Port Switch

Page 27

Installing the Bridge Hardware

2.7Setting the Serial Port Switch

Figure 11 shows the front panel switch for setting the Bridge's serial port interface.

Before you place the Bridge into service, set the switch for the type of interface used in your application:

HUP: RS±232 interface.

HDOWN: RS±422 or RS±485 interface.

Figure 11 Setting the Serial Port Switch

Serial Port Switch

UP: RS±232

DOWN: RS±422 or RS±485

Warning

COMMUNICATION DISRUPTION HAZARD The serial port switch is a hardware function. It is not sensed by the Bridge's firmware. Changing the switch setting while the Bridge is operating can disrupt communication on the network. Do not change the switch setting unless you have first verified that it will be safe for your application. Failure to observe this precaution can result in injury or equipment damage.

27

Image 27

Contents Modicon Page Breite 185 mm Höhe 230 mm Breite 178 mm Höhe 216 mm Page Data, Illustrations, Alterations PrefacePage Contents Glossary Using Panel SoftwareModbus to Ethernet Bridge CEV 300 Bridge Applications Introducing the Modbus to Ethernet BridgeBridging Between Multiple Modbus Networks Ethernet Overview Installation and ConfigurationMapping Modbus and IP Addresses Mapping for a Modbus MasterMapping for a Modbus Slave Modbus to Ethernet Bridge Modbus Ethernet Front Panel LayoutComponent Name Purpose Power Parameter Specification SpecificationsAgency Approval Parameter Specification Page Installing the Bridge Hardware Before You Install the Bridge Mounting the Bridge on the DIN RailMounting the Bridge Connecting the Power Wiring Connecting the Power WiringConnecting the Serial Cable RJ45 Port Connecting the Serial Cable RJ45 PortTSX Note Compatible Modbus Devices and CablesReferences in this figure are to the devices listed in on Modbus Cable PinoutsDB to RJ45 Adapter Kits DB9M 110 XCA 203 Connecting the Serial Cable Wiring Terminals ±WireRS±485 RS±485 / RS±422 Setting the Serial Port Switch Setting the Serial Port SwitchConnecting the Ethernet Cable Connecting the Ethernet CableConfiguring the Bridge Configuration Overview SafetyBefore You Start Example RS±232 Serial Terminal Emulator Properties Connecting by the RS±232 PortTelnet Host Requirement Connecting by Telnet IP Address Not AssignedExample Telnet Connection Connecting by Telnet IP Address AssignedUsing the Configuration Menu Configuration MenuModbus Master Device Additional Menu Items Retaining the Current Value Configuration Options 1Viewing and Changing Configuration Parameters Commands Default settings, Save, Quit without saveSet Netmask Option 1 Network/IP SettingsIP Address Set Gateway IP AddressConfiguring the Bridge Interface Type Option 2 Serial and Mode SettingsAttached Device Serial ProtocolOption 3 Modem Control Settings RTS/CTS ModeExample Slave Address Option 4 Advanced Modbus Protocol SettingsCharacter Timeout Message TimeoutAllow Modbus Broadcasts Option 5 Unit ID to IP Address Mapping Table How the Address Mapping WorksExample Address Mapping Deleting a Map Entry Entering New Address MappingExiting the Mapping Menu Adding a New Map EntryPage Using Panel Software Using Concept or Modsoft Software VersionsModbus Slave Address Worderware MMI Using Other SoftwareIntellution FIX MMI WinTech ModscanPage Glossary Framing types Default gatewayField FrameNetwork InternetLayer MAC AddressServer SwitchRepeater RouterWinsock UTPPage United States France Germany