A+ SERVER
5-6 Installing Memory
Installing Memory
1.Insert each memory module vertically into its slot, paying attention to the notch along the bottom of the module to prevent inserting the module incorrectly (see Figure
2.Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/ DIMM4A, etc. Always install in groups of four and in the numerical order of the DIMM slots. See support information below.
3.Gently press down on the memory module until it snaps into place.
Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are supported. It is highly recommended that you remove the power cord from the system before installing or changing memory modules. Please refer to our web site for memory that has been tested on the
Memory Support
The H8SGL
Populating four adjacent slots at a time with memory modules of the same size and type will result in interleaved
To Install: Insert module vertically and press down until it snaps into place.
Figure |
|
Notch | Notch |
Pay attention to the alignment notch at the bottom.
To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should
Release Tab
Front View
Note: Notch should align with the receptive key point on the slot.
release it from the slot.