Chapter 5: Advanced Motherboard Setup
I2C to PCI-Express Slot
JI2C1/JI2C2 allows you to enable the I2C bus to communicate with the
I2C to
Jumper Settings
(JI2C1/JI2C2)
Jumper Setting Definition
Closed | Enabled | |
Open | Disabled | |
|
|
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 or JPL2 to enable or disable the LAN1 or LAN2 Ethernet port. See the table on the right for jumper settings. The default setting is enabled.
Onboard Speaker Enable/Disable
The JD1 header allows you to use either an external speaker or the internal (onboard) speaker. To use the internal onboard speaker, close pins 6 and 7 with a jumper. To use an external speaker, remove the jumper and connect the speaker wires to pins 4 (+5V) and 7 (control signal). See the table on the right for settings and the table associated with the Power LED/Keylock/ Speaker connection (previous section) for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Definition
Pins | Enabled | |
Pins | Disabled | |
|
|
LAN1/2 En/Disable Jumper
Settings (JPL1/JPL2)
Jumper Setting |
| Definition |
Pins |
| Enabled |
| ||
Pins |
| Disabled |
| ||
|
|
|
Onboard Speaker Enable/Disable
Pin Definitions (JD1)
Pins |
| Definition |
6 and 7 |
| Jump for onboard speaker |
| ||
4 and 7 |
| Attach external speaker wires |
| ||
|
|
|
Note: Pins