SUPER MICRO Computer 1012G-MTF Compact Flash Card PWR Connector, Trusted Platform Module Header

Chapter 5: Advanced Motherboard Setup

Compact Flash Card PWR Connector

A Compact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will need to enable with JCF1 and connect a Compact Flash Card power cable to JWF1 first.

Trusted Platform Module Header

The JLPC1 header is used to connect a

Trusted Platform Module Header

Pin Definitions (JLPC1 )

Trusted Platform Module (TPM), available separately from a third-party vendor. A TPM is a security device that allows encryption and authentication of hard drives, disallowing access if the TPM associated with it is not installed in the system. See the table on the right for pin definitions.

Pin#	Definition
1	LCLK
3	LFRAME
5	LRESET

7LAD3

9VCC3

11LAD0

13RSV0

15SB3V

17GND

19LPCPD

Pin# Definition

2GND

4No Pin

6VCC5

8LAD2

10LAD1

12GND

14RSV1

16SERIRQ

18CLKRUN

20RSV2

LAN1/2 (Ethernet Ports)

Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, there is a dedicated LAN for IPMI on top of the two rear USB ports. These Ethernet ports accept RJ45 type cables.

LAN Ports (LAN1/2)

Pin Definition

Pin#	Definition	Pin#	Definition
1	P2V5SB	10	SGND
2	TD0+	11	Act LED
3	TD0-	12	P3V3SB
4	TD1+	13	Link 100 LED
			(Yellow, +3V3SB)
5	TD1-	14	Link 1000 LED
			(Yellow, +3V3SB)
6	TD2+	15	Ground
7	TD2-	16	Ground
8	TD3+	17	Ground
9	TD3-	18	Ground

Note: NC indicates no connection.

5-19