Chapter 3
Setup and Installation
3-1 Overview
This chapter covers the setup and installation of the blade module and its components.
3-2 Installing Blade Modules
Up to ten
Powering Up a Blade Unit
Each blade unit may be powered on and off independently from the rest of the blades installed in the same enclosure. A blade unit may be powered up in two ways:
•Press the power button on the blade unit.
•Use IPMIView or the
Powering Down a Blade Unit
A blade unit may be powered down in either of the following ways:
•Press the power button on the blade unit.
•Use IPMIView or the
•Use IPMItool when connected to the CMM to power down (if you have Operator or Admin privileges on the CMM).